Need a Guiding Light

[Lugnuts]

Attempted a search on Hydraulic Tanks that fit the air pump for the Cab Lift, etc, and turned up nothing appropriate. I am looking for replacement tanks. Prefererably not the plastic ones but aluminum. They don't crack or the helicoils don't get ripped out somehow misteriously. Any guidance is wonderful.
Thank you

 

[Lugnuts]

So I went to the parts manual and did find the part number of both gasket and reservoir and now I am asking for different information. Where can I buy reasonably priced tanks. Aluminum used? I feel I just got raped window shopping!!!

 

[Guyfang]

You could start a parts wanted thread, and maybe someone in the forum will respond.

 

[GeneralDisorder]

SPX 350887 - RESERVOIR, 0.80GAL HRZ ZN RECT 350887

RESERVOIR, 0.80GAL HRZ ZN RECT 350887

ohiohydraulic.com

 

[Lugnuts]

Thank you, guys. I looked at the tank and no picture. Do you know by chance if that tank is aluminum or the plastic? Didn't know if you had personal experience buying it?

 

[GeneralDisorder]

It's aluminum. I don't think they make the plastic one anymore.

 

[FarmingSmallKubota]

4320-01-417-2272 FMTV A0 Hydraulic Reservoir Tank 350887 ⋆ DP Equipment LLC

New, 4320-01-417-2272, FMTV A0, Hydraulic Reservoir, Tank, BAE, 350887, Power Unit, R5B6

dpequip.net

 

[GeneralDisorder]

4320-01-417-2272 FMTV A0 Hydraulic Reservoir Tank 350887 ⋆ DP Equipment LLC

New, 4320-01-417-2272, FMTV A0, Hydraulic Reservoir, Tank, BAE, 350887, Power Unit, R5B6

dpequip.net

Yep. Same part number. DP is just drop shipping from their SPX dealer. Anyone with an account can do the same and may be cheaper like the link I posted above.

 

[FarmingSmallKubota]

One of the problems i have had in dealing directly with SPX is minumum order dollar amount and x numbers of a certain item. So at least there are options

 

[fuzzytoaster]

3D printed ones are $65. It's hard to compare vs a $273 + shipping aluminum unit. will@pawnking.com

 

[GeneralDisorder]

3D printed ones are $65. It's hard to compare vs a $273 + shipping aluminum unit. will@pawnking.com

Yeah wouldn't be hard to make one from ASA with brass threaded hot-melt inserts for the lid and bolt down holes.

 

[Ronmar]

Wouldn't be particularly difficult to whip one up in steel or aluminum either

 

[Lugnuts]

I bought an Omega tank/ Aluminum/ Very little modification required i.e. a partial molding trim that does not weaken the tank/ Part #A57-6-1601-107 for the tank and the gasket is A57-3-9901-101/ The plate on the pump were it screws to the tank those holes will need to be drill out to accommodate the gasket/ Mounting holes are the same/ The total cost on those were $130/ By the way the tank was painted red so I am sure that will also need modification!!!