NHC250 Barring tool part #????

[braddrummond]

Trying to find a barring tool for the nhc250. Looks to be the same as the 5.9cummins tool ? Can anyone confirm before I buy one to try????

 

[TurboMustang370]

I have the tool for a Cummins 8.3 6cta engine, "should" be the same. I can mail it to ya as long as you promise to mail it back when done in the same condition. PM me.

 

[braddrummond]

Thanks, Does it have a part # on it? I've found a few online just wanted to confirm before buying. I have a Dodge diesel also, so I was just planning to buy one if its the same.

Brad

 

[TurboMustang370]

Thanks, Does it have a part # on it? I've found a few online just wanted to confirm before buying. I have a Dodge diesel also, so I was just planning to buy one if its the same.

Brad

I'll look at for a part number when I get home. I tried finding the online store I purchased it from again and cannot locate the site.

 

[Scar59]

Can you post a picture of the barring tool?

 

[TurboMustang370]

This is the one I used for the 8.3 6CTA in the M932a2

 

[Scar59]

Thank you, a picture is worth a thousand words, (or the applicable section of the TM). It would be a little tricky to fab one up.
JC