oldmodelmaker2
New member
- 4
- 0
- 0
- Location
- Davenport, Florida
Generator runs great, starts easy has 120 volts at outside recepticals shows 240 volts on voltmeter when switched to 240 but there is no voltage at the L1 L2 L3 LO posts. Hertz adjust to 60 with no problem. Have load tested it with two 1500 watt heaters for one hour with no problems. What could the problem be? Any help appreciated I have owned this gen. for more than 20 years and have used it during several hurricane outages using the 120 recepticals for lights and refrigerator. Have never used the line post but would like to use the 240 volts to run my well pump when power is out. I do not know the model no. of the unit as there is no id. tags on it. It has a contactor switch and knob that says contactor closed or open. Where would the contactor be located on this unit? I think it is an older MEP002 but not sure.
Last edited: