Ian88
New member
- 2
- 5
- 3
- Location
- Vancouver Washington
Just purchased a M1038a1 from a buddy and just finished installing the new engine in it , I came across 2 open ports on the power steering system I’m assuming went to the hydraulic winch that did not come with the truck I’m wondering if I can plug them up with caps or do I need to run a hose from each port to connect them ? I didn’t see a schematic in the manual for it here are some pictures - any help would be much appreciated! Also what threads are they ? I could make a cap on the lathe unless it’s an off the shelf part I can snag easier
