CanonNinja
New member
- 778
- 7
- 0
- Location
- Houston, Tx
Kinda stumped how to get the glass out of the arms on the regulator... dont want to flex anything and break the glass.. Thanks guys!
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Quick question... removing glass from window regulator
- Thread starter CanonNinja
- Start date
papercu
Active member
- 2,935
- 30
- 38
- Location
- Baxley, Ga.
pa.rich
New member
- 1,323
- 9
- 0
RE: flexing
I like where it says "slide glass out of frame" ----- There is usually so much rust in that glass seat channel, it is difficult to remove.
I like where it says "slide glass out of frame" ----- There is usually so much rust in that glass seat channel, it is difficult to remove.
papercu
Active member
- 2,935
- 30
- 38
- Location
- Baxley, Ga.
Frame
If you were in the military, most times you would order a new channel at the time you ordered the glass. Wayne
If you were in the military, most times you would order a new channel at the time you ordered the glass. Wayne
- 7,583
- 358
- 83
- Location
- Cheyenne, WY
Should just slide out.
CanonNinja
New member
- 778
- 7
- 0
- Location
- Houston, Tx
i figured it out.... it was hung up on the nasty crud in the channels and one of the weatherseal clips... looks like i need a lot more than I thought
- 7,583
- 358
- 83
- Location
- Cheyenne, WY
All those parts are relatively easy and cheap to get. 