nickd
Active member
- 867
- 44
- 28
- Location
- Newport, Delaware
Anyone have information on lubrication for the m66 ring mount. Mine turns but its a little stiff. suggestions?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
ring mount lubrication?
- Thread starter nickd
- Start date
Tony
New member
- 141
- 1
- 0
- Location
- Camarillo, Calif 93012
I have the same mount, it was frozen, took it all apart and freed up the bearings. I'm in the process of restoring my M-135 and I'm not to the point of putting the mount back on with the skate. I intend to repaint the ring, and not paint the part that the skate runs on. So far the only thing that I could think of to put on the ring is some sort of silicon lube which would not attract to much dirt. About the bearing, I haven't gone that far.
Let me know what you do
Let me know what you do
nickd
Active member
- 867
- 44
- 28
- Location
- Newport, Delaware
Mine is not stuck it just a little stiff turning
- 7,065
- 159
- 63
- Location
- Mid Hudson Valley NY
What does the TM say to use?????????????
nickd
Active member
- 867
- 44
- 28
- Location
- Newport, Delaware
do not have the TM anyone able to check for me???
Jones
Well-known member
- 2,237
- 83
- 48
- Location
- Sacramento, California
No lube as it's an open bearing. Any kind of grease in there would attract and hold dirt. Our motor pool guys say to run them dry and ocassionally blow them out with an air nozzle. (Everyone I've ever tried sounds dry when it's rotated). Constant use keeps them freed up so give yours a spin every once in a while.
rdixiemiller
Active member
- 1,760
- 5
- 38
- Location
- Olive Branch Mississipi
Use dry graphite. You can still buy it in the little plastic squeeze tubes. It is used to keep lock cylinders working smoothly.