transmission and transfer case torque arms

[cjkeeliii]

I read in a previous post about torque arms for the transmission and transfer case. my transfer case adapter is cracked and I am going to replace it. I have heard that the 454 set up uses torque arms between the engine the transmission and transfer case. is it possible to use the same set up on a 6.2 liter diesel or has 1 already been configured and they just did not put it on the military trucks?

 

[NPD732]

All the civillian trucks had those braces from the factory. For some reason GM didn't put them on the CUCVs. Probably cut 2 bucks off the contract price. You need the transfer case brace. Any one from an auto trans/208 setup will work. There are also 2 braces that run from the bottom of the bellhousing to 2 plates that are between the block and the motor mount perchs. They maybe the same as the 454. Best bet is to snag them from a civy 6.2. I added these to my M1031