TURN SIGNAL BEEPER.... BEEP.... BEEP.... BEEP........

[Tiwaz]

does anyone know of a turn signal beeper you can adapt to the Humvee turn signal lever or in lu of that, a super bright light so you don drive around like a dumb ass....?

 

[DREDnot]

Yours should have had a self-cancelling type lever assembly.

There is an LED bulb for the indicator that is much brighter. It needs to be a special BA9S reverse polarity bulb in order to work though.

 

[FlameRed]

Get a real military self cancelling lever which are expensive and hard to find. The Chinesium ones that are prevalent suck and require a lot of force to self cancel and so often break the tabs on the cancel ring. The real military ones are require very little force to self cancel and so do not break the tabs on the ring.

Most of the rings out there are 3D printed and not very strong. To strength them up, I drilled a small hole going through the center of each tab and screwed in a small screw.

 

[Tiwaz]

ok..... ABOUT SELF-CANCELING

ok I do have self-canceling and it works very well, the problem though is when you are going straight (Maybe on a highway) and you decide to shift lane... maybe 2 lanes, you put your turn light and because you never steered hard enough the self-canceling gizmo will not engage, 10 minutes later you realize you been driving with your turn signal on like a moron. That is why a very bright LED or an audio device would be good for me.

 

[Tiwaz]

Yours should have had a self-cancelling type lever assembly.

There is an LED bulb for the indicator that is much brighter. It needs to be a special BA9S reverse polarity bulb in order to work though.

DREDnot, can you give me a link or more specs on that bulb so I can look for it on the internet...?
And why does it need to be REVERSE POLARITY....?

 

[simp5782]

Splice it into the wires that is sending out power for the turn bulb for each side at the switch harness. If its too loud then put some tape or liquid nail over the speaker.

https://a.co/d/dAc5RW4