CallMeColt
Well-known member
- 1,116
- 1,655
- 113
- Location
- Wilson County, Texas
Good thread. I just got my LMTV & this has a minor leak. Will start with taking it apart & seeing if it can just be cleaned up.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Valve Leaking on side of Wet Tank
- Thread starter kenet3621
- Start date
spankybear
Well-known member
- 917
- 967
- 93
- Location
- WA
Has anyone found an after market replacement for the valve?
spankybear
Well-known member
- 917
- 967
- 93
- Location
- WA
314107013
Third From Texas
Well-known member
- 2,821
- 6,643
- 113
- Location
- Corpus Christi Texas
Wow, no US Haldex distributors?
- 415
- 894
- 93
- Location
- Daytona, FL
Reviving an old thread….the rubber diaphragm in mine has a semi circular tear in the center..normal or shot ? remedies anyone ?
Last edited:
MrMikey4026
Well-known member
- 281
- 417
- 63
- Location
- Eatonville Washington
Every commercial truck with air brakes has a pressure protection valve, it is available wherever truck parts are sold. (including NAPA)
The pressure setting does not much matter as long as it is somewhere between 70 and 85 psi.
All it does is shut off the air supply to nonessential devices, air horn, cab air, wipers, CTIS, fan clutch in the event of a major air leak thus protecting you brake air supply. They go for about 28$, most are now non-adjustable.
The pressure setting does not much matter as long as it is somewhere between 70 and 85 psi.
All it does is shut off the air supply to nonessential devices, air horn, cab air, wipers, CTIS, fan clutch in the event of a major air leak thus protecting you brake air supply. They go for about 28$, most are now non-adjustable.
Ronmar
Well-known member
- 4,196
- 8,025
- 113
- Location
- Port angeles wa
The one on the LMTV is set to 85 PSI per the TM. It is really just a rubber disc. If you can find the same thickness material you could cut one. I would recommend silicone grease over RTV/sealant in this application…