TexAndy
Active member
- 1,427
- 15
- 38
- Location
- Bee County, Texas
They'll do 85 without much trouble. I got mine to go that fast on I-37 south of San Antonio just to see how the vehicle behaved. Wasn't difficult at all.
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
That's the system I installed in my m1009. I went with the stock appearing turn signal lever and yes you do need a vehicle speed sensor (VSS) The one I used attaches to the end of the speedometer cable inline down by the transfer case this is the part number from Rostra if i remember right, 250-4153. I was thinking of using a stock setup till I tried to pull one from the boneyard. way to much work to do, to get a system that could end up being nothing but junk in the end. its been 4 years since i installed this and no issues yet, took about a day for the install. holds the set speed dead on.
Is there a tachometer gauge that would properly display this signal? I'd been reading other threads about mounting a tach on an M1010. I'd been planning to glue magnets to the bottom pulley to get a signal for an ISSPRO R8503, but it sounds like it would be much cleaner to use this signal.The alternators have tach output but it is a pretty high frequency AC output, don't know how it could be used. Left alternator has a brown wire which goes to the tach buffer module for the STE-ICE diagnostic port. I guess I could test it out on mine
just back, 320 Hz at fast (cold) idle, 200 Hz once warm.
I have no idea if this is the way to figure it but, I'm looking at two different manuals. The Rostra one and the CCS-100.The alternators have tach output but it is a pretty high frequency AC output, don't know how it could be used. Left alternator has a brown wire which goes to the tach buffer module for the STE-ICE diagnostic port. I guess I could test it out on mine
just back, 320 Hz at fast (cold) idle, 200 Hz once warm.
What did you do with your windshield wiper/sprayer controls? the replacement lever just pops in everything works the same just adds cruise switches
We get it, advertisements are annoying!
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!