-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Latest activity
What's new
BMI
Midwest Military Equipment
Eastern Surplus & Equipment Co
-
IIcesythe7 replied to the thread MEP-803A Low Voltage.I'm having this exact same issue on my 803a, if s1 held to start voltage is fine, once it is in run it will slowly drop from 120v down...
-
JJimC2 replied to the thread XM708 refurb.Looking forward to getting the new tires mounted. Narrow 9" tread width and 38" height. And I'm starting to think about also refurbing...
-
-
Scoobyshep replied to the thread MEP-114A GPU.Of all the sets I've worked on that had that model of fuel pump I think I've only had one that was not salvageable. I recently cleaned... -
Aazreark1 replied to the thread MEP-114A GPU.So the one that isn’t running, if i take it apart and clean it then it should work again? That has literally never happened to me with...
-
G744 replied to the thread Superthermal's M813 Build, THE BOT.If you haven't found another 70+gal tank or winch, PM me. I can help you out. Dennis aka G744 -
887cr250r replied to the thread CUCV early Glow Plug burn out - What is the cause?.Rubber hose can make a perfectly acceptable long lasting replacement IF you get the right materials. SAE J30R9 and 10 hoses will last...
-
Scoobyshep replied to the thread MEP-114A GPU.There are off the shelf options available that will function however tearing the existing pumps apart and cleaning them cost you maybe a...
-
Aazreark1 replied to the thread MEP-114A GPU.Well the filter canisters were deff nasty, water inclusion and stuff, only the rear pump is working, easy options for jut removing them...
-
Ggrywitt replied to the thread Mep 831A load issues.I did make one troubleshooting mistake when making this new video. It might be that sitting with sea foam made the difference and not...
-
Ttopo replied to the thread M809 front winch spins the wrong way.The front winch on my m52A2 was like that it payed off from the bottom some time back I unspooled the cable and put it on the right way
-
Ggrywitt replied to the thread Mep 831A load issues.https://youtube.com/shorts/tAAsPIdXzy8?si=jxNNoynAacGKmqvX Here I think is proof and hopefully a clue for someone more knowledgeable...
-
-
DThese are hard to find but I finally found some new armored windshields. I picked these up Thursday. Brand new ones for driver and...
-
Rradioguy971 replied to the thread ibis tek 24" light bar pin out diagram.thanks for your response. Do you have any information on the main connector pinout for the dual joystick controller? I'd like to wire in...
-
JJimC2 replied to the thread XM708 refurb.Ordered two more 1050x16 directional tires, tubes, and flaps today, for a total of four. Gotta get the rims bead blasted and painted.
-
marchplumber reacted to wgtactical's post in the thread Journey complete, 52 years later... with
Love.
Been a while since we updated the Blood Sweat and Tears search. As it turns out, the reason nobody remembers "Blood Sweat and Tears" is...
