-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Latest activity
What's new
BMI
Midwest Military Equipment
Eastern Surplus & Equipment Co
-
Guyfang replied to the thread MEP-114A GPU.No Bus fuse, no battery charging. The set runs on 28 VDC, so if the battery charging alternator is non op, and the batteries are low... -
There are off the shelf options available that will function however tearing the existing pumps apart and cleaning them cost you maybe a...
-
Been a while since we updated the Blood Sweat and Tears search. As it turns out, the reason nobody remembers "Blood Sweat and Tears" is...
-
Reworked LMTV reacted to coachgeo's post in the thread Not Dead. myself or alternator .... and other happenings with
Like.
LMTV has remained daily driver.. NOT BY CHOICE... its only thing that runs.... (though alternator not run in 2.5yrs.) Speaking of... -
Tinstar replied to the thread Another, but unique ID request.I would buy it just on its uniqueness alone! Never seen one of those before. Talk about handy! -
LLuckeyD replied to the thread MEP-1050 Fault Code 3665.Good Day: S12 looks good, (sometimes these do go bad so move them a couple times) but if the DCS still indicated the 3665 error, you...
-
LLuckeyD replied to the thread Mag Pickup repairs on my MEP804 a.Well, you can try the procedures starting on page 2-306 and ending on page 2-307 and hopefully that one turn will clear the flywheel...
-
CFor patterning muslin would be fine. I've also used lightweight packing paper, like Amazon or others sometimes stuff into boxes. If you...
-
IIcesythe7 replied to the thread MEP-803A Low Voltage.I'm having this exact same issue on my 803a, if s1 held to start voltage is fine, once it is in run it will slowly drop from 120v down...
-
JJimC2 replied to the thread XM708 refurb.Looking forward to getting the new tires mounted. Narrow 9" tread width and 38" height. And I'm starting to think about also refurbing...
-
-
Scoobyshep replied to the thread MEP-114A GPU.Of all the sets I've worked on that had that model of fuel pump I think I've only had one that was not salvageable. I recently cleaned... -
Aazreark1 replied to the thread MEP-114A GPU.So the one that isn’t running, if i take it apart and clean it then it should work again? That has literally never happened to me with...
-
G744 replied to the thread Superthermal's M813 Build, THE BOT.If you haven't found another 70+gal tank or winch, PM me. I can help you out. Dennis aka G744 -
887cr250r replied to the thread CUCV early Glow Plug burn out - What is the cause?.Rubber hose can make a perfectly acceptable long lasting replacement IF you get the right materials. SAE J30R9 and 10 hoses will last...
-
Scoobyshep replied to the thread MEP-114A GPU.There are off the shelf options available that will function however tearing the existing pumps apart and cleaning them cost you maybe a...
