-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Latest activity
What's new
BMI
Midwest Military Equipment
Eastern Surplus & Equipment Co
-
Looking forward to getting the new tires mounted. Narrow 9" tread width and 38" height. And I'm starting to think about also refurbing... -
Well, you can try the procedures starting on page 2-306 and ending on page 2-307 and hopefully that one turn will clear the flywheel...
-
Good Day: S12 looks good, (sometimes these do go bad so move them a couple times) but if the DCS still indicated the 3665 error, you...
-
To answer the injector test question, yes, that's sort of how to do it on the machine, but I would do something so you aren't spraying...
-
I do keep it in a conex that has good seals but I definitely will rodent proof it if and when it's susceptible to them. I already killed...
-
That seems like progress in a number of areas! The rewiring looks nice. Rodents can do amazing amounts of damage in such a short period...
-
Well i figured out the debris. Just a lot of sticks and twigs,leaves ect down by the exhaust and close enough to get burnt then fly out...
-
Mullaney reacted to Coug's post in the thread What have you done to your HMMWV today/lately with
Like.
I pretty much gave up trying to keep track of mileage in mine. Half the time I drive it it's either short trips, towing trailers... -
Mullaney reacted to Reworked LMTV's post in the thread My Dad loved my M1009 CUCV TNARNG #04 with Like.
Sorry for your loss. Wear a shirt with with the pictures you have here pressed on it. It will help carry his memory. I like the SNORKLE...
-
Commander5993 reacted to 87cr250r's post in the thread CUCV early Glow Plug burn out - What is the cause? with Like.
Rubber hose can make a perfectly acceptable long lasting replacement IF you get the right materials. SAE J30R9 and 10 hoses will last... -
Just took a guess and did TM recommended Square knot tie offs. For roof did one at roof where hits Eve area on both sides. From... -
2No Bus fuse, no battery charging. The set runs on 28 VDC, so if the battery charging alternator is non op, and the batteries are low...
-
2Of all the sets I've worked on that had that model of fuel pump I think I've only had one that was not salvageable. I recently cleaned...
-
2There are off the shelf options available that will function however tearing the existing pumps apart and cleaning them cost you maybe a...
-
22Pbfeet replied to the thread Mep 831A load issues.To answer the injector test question, yes, that's sort of how to do it on the machine, but I would do something so you aren't spraying...