olly hondro
Well-known member
- 905
- 593
- 93
- Location
- tucson AZ
would I care if I completed my circuit through the chassis or the firewall mounted ground bus ?
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

would I care if I completed my circuit through the chassis or the firewall mounted ground bus ?
Yes, I recall that from high school vocational training : "Holes are positively charged quantities of nothingness that move oppositely of electrons." OK. Anyway, this is what I'm doing, under construction still. The wires that went to the ground bus are now attached to the passenger side frame rail. The +24 volt red cable that goes to the rear busses is unmolested. The black cable to the rear bus now transports positive holes under 12 volts of pressure. Now, positive stuff does not like to dress in black, but will have to get over it. The rear ground bus is now also 12 V, stuff back there also grounded to the frame. I did this because the batteries are in back, as is the winch.I agree with Marcus, we don't need to go down this rabbit hole. Though that was the reasoning to the positive grounding of vehicles in the 1950's. Electrons flow from the negative to the positive. They figured it would provide a better electrical system. We now know it makes no difference which way your connecting the polarity. Just don't jump start an old "L" series IHC with negative to ground ! Besides the whole 6 volt thing you'll get quite a "shock" out of it !!!Electrons don't move to the right.
The holes move to the left.
Double triple ground everything back to negative, can't hurt.
Where is negative?

Hmm, I think I knew her."Holes are positively charged quantities of nothingness that move oppositely of electrons."