Today I replaced the turn signal cam and now my brake lights don't work.
I went through the -20 to try and find the problem but nothing I found there fixed the problem.
The fuse is good and I'm getting power through the stop light switch (replaced it too today). I adjusted it and re-installed it twice.
I thought it might be a grounding issue but all headlights, tail lights, and turn signals are working...just no brake lights.
When the turn signal is on and the brake is pressed the turn signal stops flashing.
It appears from the wiring diagram on the -20 that the brake light wiring might pass through the directional signal & hazard flasher switch, but I cannot figure out how or why.
I only replaced the top part of the turn signal cam. The old one was cracked where the turn signal arm was attached. I had to separate the two parts of the cam and use the brass springs and clips from the old cam.
Where did I go wrong?
I went through the -20 to try and find the problem but nothing I found there fixed the problem.
The fuse is good and I'm getting power through the stop light switch (replaced it too today). I adjusted it and re-installed it twice.
I thought it might be a grounding issue but all headlights, tail lights, and turn signals are working...just no brake lights.
When the turn signal is on and the brake is pressed the turn signal stops flashing.
It appears from the wiring diagram on the -20 that the brake light wiring might pass through the directional signal & hazard flasher switch, but I cannot figure out how or why.
I only replaced the top part of the turn signal cam. The old one was cracked where the turn signal arm was attached. I had to separate the two parts of the cam and use the brass springs and clips from the old cam.
Where did I go wrong?