Recent content by acmunro

Yes use the search don't ask the same question over again. But be patient.

I always think it is strange the CUCV trucks did not have these but the civilian trucks did.

Looks like a good project. I would like to see the pics from your roof cap retrofit.

I would I bought a lot of 10 ramps. I should have a couple extra.

I picked up the lot I had pictured. I am not sure what they are from. They are aluminum. If they are boarding ladders they were built for elephants...

I thought it was an odd design for a vehicle ramp as GL had them listed. Now we know the truth.

Thanks

Thank you. Are they steel or Aluminum ?

Hello, Did anyone preview these ramps or recognize them ? Just trying to figure out if they are steel or aluminum. Also how much weight they were designed for. Thanks in advance.

I did on a 6.2 I installed in a 97 ex USAF crewcab. It came with the truck on the blown 6.5.

Yes I forgot about the short injectors and lines. I really need to start writing this stuff down. I always think I will just remember. Thats not happening.

Looks like everything is there in the picture. Not sure if the Air cleaner is included that might be helpful. The one I did I used some pipe fittings at the bell housing oil port to tee off for a oil pressure line to the Turbo. From the tee I used 3/8" stainless steel line to come up near the...

Welcome and Merry Christmas from Brookville, PA Just down the road on I-80.

I will be following this thread. I have been kicking around the idea of building a genset this way but using a Detroit Diesel 2-53 I have. I like the idea of having a quiet generator LOL.

Come anytime. It might be a couple degrees cooler up here. Prob just as Humid.