Recent content by Apex02

Put a high rack on the back for hunting season

Has anyone drilled drainage holes in the bed? Just curious if there would be any downside in doing so. I don't want a cargo cover but also don't like the water pooling up near the doghouse

Got it. I'll check this. When I tighten the knob all the way the brake won't set so I guess you can over tighten it. I'll keep an eye on this going forward. Thanks for the advice

Maybe this is a dumb question but does the parking brake not work when the shifter is in reverse? I had the truck off, e brake on, and the shifter in reverse and had to chase the truck down the driveway to stop it. Seems to hold the truck fine in neutral and drive

Here's mine with windshield folded. Currently getting a high rack built for quail hunting

Nwappleby--where are you in houston? Trying to find other guys in the area that have hmmwvs

Unfortunately never did find the issue--I did find that my front composite light was out because the wire was severed inside the front composite light housing itself--but I don't think that would have caused a spark inside the cab on the floorboard. Everything else works fine and looks fine

I'm down in houston. So is the converter for the whole truck or just wired into the feeder?

I'm new to all this and am trying to figure out what I need to do to hook up a 12v corn feeder into the rear trailer hitch. I already have the 2" receiver bracket installed and I have the toggle switch. Just unsure what I need since the Hmmwv is a 24v system and the feeder would be 12v

Just drilled holes in the radio tray for the drop in cup holders. Gun rack is a rugged gear 4 gun floor mount which tilts and swivels allowing you to mount it at many different angles. Just slapped some tan paint on it.

Cup holders in radio tray and a 4 gun rack

Yeah that picture is not from Huntington Beach --kinda looks like a scam. Website down and email address is in Europe. Try the phone number listed

Just was going over my truck that I got last week and noticed the left rear half shaft seems to have some spacing at the wheel. Figure this is not good. Anyone know what the fix for this is?

Does anyone know where I can buy the tan or green fabric that covers the seats? I am looking to cover a high bench seat in the bed so pre made seat covers will not work

Yeah I still have the big radio plug coming out of the tunnel. And those aren't damaged wires in pic. Here is a better shot--it's just 2 wires coming out of a rubber housing that I guess connects both of them