Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
The rod is the spool control valve, it directs fluid flow " raising and lowering the bed". That type of pump has a built in relief valve. you just plumb the pressure line from pump to your dump cyl. and a return from your pump to your tank. along with a supply line from tank.
No difference in #2 Highway and Off Road Diesel, when you load it at the rack the Green Diesel goes in and injects red dye in it as its loading in transport. K-1 , HHO, Jet A is pretty much the same thing, it all loads out of the same arm at the loading rack. Premium #1 Diesel is #2 and k-1 mix...
Let me help you, Everyone missed this. His only experience is with electric brakes, 99% of electric brake controllers operate off of time. The longer the pedal is held the more current that is applied to the electric brakes at the wheel. When empty you turn the voltage down so the tires don't...
Driving it sounds easy, but you have 600+ miles to drive a unknown commercial truck. If it breaks down the tow bill would be quite large, does the driver you hired have a cdl a current dot physical card, our they on your insurance, do you have the right state trip and fuel permits to make the...
You can actully run a 4L80 with 4 wires and a couple toggle switches. Those have a constant 12v to the trans and 2 shift solenoids inside that shift on grounds, ground A solenoid you get 1st no grounds 2nd B solenoid gets you 3rd, A and B gets you overdrive. One more switch will get you tc...
Telling if the 300 is a big cam is easy it will have big cam cast in the left side of the block. Then its just as easy to tell what generation its because it will say big cam,2 3 or 4 in 2 inch letters. You have to look up the cpl # to see how the motor was internaly set up as to how much hp it...
I also have a DS4 pump in working order that was on the motor when it blew, and a DB2 that was on a low mile 6.2 in a cucv2 that took a hard hit in the ass but the motor ran sweet, it has ip lines for the short injectors. I also have the mechanical waste gate controller that looks like new. I...
I lay a 6x6 down about 2 ft in front of the step on my step deck and back right up on there. Just go slow and easy and you can't even feel it. So it does just climb right up there.
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!