Recent content by CanonNinja

Gotcha. Out of curiosity, what is that little slice of heaven in your avatar?

Gracias. M915 looked all wrong, add the A2 and yeap, that's the truck I was thinking of. Trying to figure out if I need a class B Except w/air brake endorsement, or a full-on Class A CDL to drive thing.

mmm... maybe? What truck is that exactly?

Way smaller than the 915. I cant remember if it was a Freightliner or not, just that it was essentially a commercial chassis in CARC, I believe they were mostly 5spd Allison autos, no front drive axle. Edit: Maybe I'm just an idiot and my Google-fu failed me

I've seen quite a few of these in the past, smaller trucks than the M916, but cant for the life of me remember what the **** they were. Pretty sure this is one of them, but again I cant find diddly squat after searching for an hour now.

Not a lathe no, but I have plenty of access to grinders and torches

What I have done thus far is removed everything save for the spindle and brake components. I'm guessing that blocking off the air line and swapping to A2 bearings and hub seals doesnt quite cover it.... guess I'll be pulling the spindle this week and removing this garbage.

Definitive answer to Swapping M35A3 front bearings and seals to A2 goodies Well, Ive searched like crazy, and cant find anything that answers my question. I have torn down a grenaded A3 front bearing and ready to put parts back on, and need to know...What exactly do I need to modify on the...

well, looks like the buyer welched on the truck, gotta relist it for sale. Guess I should mention CTIS will now be disabled on the front axle =/

The main issue is right now the old bearing and race are stuck on the spindle, preventing me from getting the hub and drum off. Not much room to work with

Well, looks like im going to just convert the one side to A2 stuff, with the new seals, bearings and spindle. Is the hub going to be the same, or will I need to snag one off a parts truck?

Im gonna call a few of them tomorrow and see what I can come up with. Right now, CTIS is not working, there's a leak in the rear most axle somewhere, and my $400 for work I had done by CM Automotive on the controller was for naught, as the **** thing is going haywire again. He wants the...

I'm trying to source the spindles, but no luck so far =/ part number i need is 12448552

The A3 spindles are side-dependent because of the CTIS system. This is turning into possibly the worst case scenario here. Even if I get this drum off, there seems to be several small A3-specific parts that may not be worth replacing, vs swapping the entire front axle :-(

replied to the wrong thread