Recent content by captkennyboy

no luck

thanks didn't think to check for the 24 volts. i replaced the engine wiring harness when i first got the truck - i will test it!

Thanks the fan does not move back and fourth when i disconnect TDM and the sound doesn't change . the fan can not be moved when the truck is not running which i understand is normal.

Hi all, I’m working on my 2004 M1123 with a 6.5 non turbo. The radiator fan clutch stays engaged all the time. I have changed the Fan Clutch solenoid valve, Thermostatic Fan Switch and the Time delay module and still no change! Any help would be greatly appreciated. Thank you in advance

I like your mount for the tach. I'm getting ready to install one and was wondering how you fabricated the mount? I also noticed you are in CO as am I not far from you and would like to buy one if possible thanks

thanks works perfect!

Hi all, does anyone know were i could find the straight rubber coupler on the bottom for the snorkel. I have noticed some of the HMMWV use this to raise the standard intake cap thanks in advance for the help

Thanks

thanks to all for the replies I have a basic M998/M998A1 without a winch - 1986 with a 6.5l engine.

Quick question i run with a group of HUMVEE owners off road - most M998s and my M998 rides considerable rougher and harder. all the tire pressures are the same around 25 PSI. Did HUMVEEs have different suspensions? Do some have a softer ride? thanks

Thanks for the fast reply

Thanks in advance for the help. I have changed the glow plugs on my M998 and didn't pay attention to which wire goes to which plug. Does it make a difference?

how does one go about getting parts thanks

not sure about the title issue but does any know how to get parts for the Growler M1161 ITV-LSV 4x4

i had to drive in reverse more than a 100 feet. I went half way down the block and then it shifted out