Recent content by cptd

Even if you are not interested in buying mine, you are welcome to come to check it out and I can walk you through my truck and some issues to look for. I have not posted it for sale in the calssifides as I have to touch up the paint. PM me if you are interested. I can send pics and/or talk...

I tried those part numbers and when I tried them on my doors they were too short. LMC clearly lists those part numbers as for a 79-81 and they do not list a part number for anything after 81. I returned them to LMC and am still looking for a replacement from other sources. What am I missing...

Went on an unscheduled mudding jaunt the other day. In cleaning up after my behr tan paint job showed its weaknesses. Result being that there are touchups necessary all over the truck. Maybe whole sections re-painted. Any recommendations for behr repair tips? Seems the behr didn't bond to the...

No replies? Please assist. CPTD

So after all of your suggestions here is the latest: I have replaced every switch (headlight, turn signal, dimmer, ignition), I have replaced all bulbs three times, I have replaced all fuses three times. I have traced all of the wires at the rear end of the vehicle. I ran a jumper from the...

Bump I'm interested too.

What is the difference between the turn signal and turn light switch? CPTD

Yes I do have dash and all other lights. The only lights that don't work are stop lights and the blue high beams indicators. CPTD

Yes I have turn signals, front and rear. Markers front and rear. Reverse lights. Headlights. All lights except the brake/stop lights. I have voltage at the brake switch in and out. I am lost reading the wiring diagrams and tracing the wires into and out of the fuse box. CPTD

Thanks for the suggestions. I have checked the BO switch. It is good because I have horn headlights and all other. CPTD

I have been searching for a solution to my brake light problem, though others seem to have similar issues, I haven't found a solution to my problem. I have however tried as many things as I could from other folks suggestions on other threads. I have no brake lights, period. I have checked...

I have been searching for a solution to my brake light problem, and though this is an old thread, this seems to be the best place to start. I have no brake lights, period. I have checked continuity on the brake light switch, it is good. I have checked for power on both sides at the rear of...

Replaced left front hub, bearings, seals, spindle, spindle nut and both lockers. Repacked right front wheel bearings and seal. Replaced front brake pads. I'll check the stuff you guys suggested and report back. CPTD

I have an M1009 with 16" rims and some nice coopers on the wheels. I have 2 questions: 1. When at right lock I am getting some rubbing from the drivers side tire on a steering component, I think it is the pitman arm. I do not know what the offset is on the wheels and would like to...

Thanks for the responses on the paint codes. I think I have that problem solved. Next question to be answered is.... Do I need to prime anything that isn't taken to bare steel? One of you wise fellas said that the acrylic paint should stick well to the flat CARC like paint very well. should I...