Recent content by D Foster

Is it posisble that I have a different type/model Gear Fan Drive setup? I can't seem to located my fill and drain plugs behind my fan? I have checked underneath and also top side on the engine area behind the fan and can not locate the plugs or type of fan assembly? Thanks for your help.

Thanks for all your information and photo. It was very helpful. I will probally do something like you did to get excess to the plug.

I have a 2008 1165A1 HMMWV and wanted to check/lub if needed my ENGINE FAN GEARBOX? I have not beeen able to find the fan gearbox plug or reservoir? According to the manual photo it is part of the fan assembly, under the fan itself? Any help would be appreciated. Thanks!

Hello, Mine does not go into the red at all. Mine pulsates approx. 60-90 seconds and levels out into the green only. While pulsting before leveling out it stays into the green. Mine tends to start off into high yellow for approx. 20 seonds. I can correct this by increasing my RPHs...

THANK-YOU! I appreciate the quick response. The website is a wonderful thing.

When first starting the engine, the rpm's pulsate on the engine and electrical system for approx. 1-1 1/2 minutes than goes to normal? When this occurs my headlights, signals , etc. all fluctuate in addition to the engine. After this stops, the engine & electrical system appears to work fine. I...

Thank-you both for your replies. Yes I am looking for the wires to plug into the pump wires. So far I only have located what I believe is hopefully the positive plug under the dash. It is numbered 57D. I notice one of the pump wires is numbered 57 so I am hoping this is the positive. If I...

I have a 1165A1 and attempting to getting my wiper washer pump operating. The pump was unassembled during armor de mill. Looking at what diagrams I have seen it appears there should be two wire connectors under the dash near where the pump/reservoir tank are located? I have not been able...

The only thing I can tell you the pin pattern on mind for the wire remote has three pins that are the same distance apart and triangular shape. There's a different three pin pattern on same that are not equal distance apart. Hope this helps.

When I purchased mind he demonstrated by have the winch hooked up with large cables to 24 batteries. He only used the wired 12' remote. The wired remotes are overpriced, I agree. My winch did come with large 2 cables to hook to battery.

You may have purchased your series 18 winch from the same person as I ? Before realizing it would not fit between my frame member I had purchased a 12' wired remote . I now have it for sale on Craig's List. I plan on installing the smaller 12 series on my Humvee. My series 18 has a small...

I know the guy I had purchased the series 18 winch from was from Maryland. I believe he was purchasing his winches from auctions on the east coast south areas. Of course these came off larger vehicles and not humvees.

I am approx. 1 1/2" hours from Wildwood. Located in Franklinville, NJ. If your serious I can take a photo and email it to you.

I want $1,500 cash with new 12' OEM remote. Before I purchased this the seller tested it. Works well. Where are you located.

Thanks for the information. From all information I have received doesn't look like it will work. I will probably end up selling the series 18 winch and remote. Take Care, Dennis