Recent content by derby

Please enter me!

Everything worked properly when I parked it. I purchased it back in 08' and have had no electrical issues with it at all. I replaced the stalk and flasher with new replacement parts. I may have to look harder at my repair and other parts of the harness for damage. I will give the long jumper a...

What TM do I need to check the turn signal circuits? I replaced the flasher and the turn signal switch, it only worked for a minute and I am back at square one.

Thanks for the info.

I recently pulled my dump out if its slumber. I was going over items like tires, fluids and lights. The headlights and taillights are fine. I had no turn signals or hazards. I assume a raccoon chewed the wires to the signals judging by the surprise in the battery box. I repaired the wires, the...

Thank you all for the information. It was the vr board. Up and running like a top. I ordered a vr board from Jim at Lakeland services. Shipped out fast, no complaints.

I will look into this and get back. Thank you for the information!

Thus spring I had a power outage and fired up the Mep 003 . I have had this unit since 09' I start it and run a load or no load test on occasion. I had a voltage spike to about 190v sending a few power strips to the smoke god. The voltage output adjustment has no affect on the voltage. I did...

Thanks! That's exactly what i was looking for.

I can't seem to open the link.

Yes the sleeve and pin that controls the fuel collar.

Hello all , I have an issue with the multifuel fuel pin location. I have an lds2 that I saved for my dump truck that I won't be needing. I have not tried to start it in years. Long story short, the fuel pin was sticking holding it in the off position. I tried cleaning it externally but no luck...

What ever became of this project?

Uh, I was thinking the same thing........ Thanks for the TM I will dive into it tonight. Also I prefer Log Cabin,

Which TM do I need? There is a vent on the bottom of this unit about the size if your thumb that faces down. About 8" in diameter round,has alot of air lines and a wire harness with about 6-8 wires pluged in the side. I can't get a pic until I go back after the Holidays.