Recent content by djglover7

Did you ever post pics of the " U-shaped pieces that were each only about 1-1/8" tall " process?

Possibly. I think two spares up top make sense to me. Couple of downsides though. - Taking up space in the trailer. - Having to lift the spare out.

Pics Note: last pic is where I added a rivet nut to store the bolt. Intent is to remove from sidewall when not in use.

Took a different approach. The wheels are 245/75-17 (GM rims) and the spares (2) fit perfectly in front of the wheel wells, upright. I attached a 1/2-13 rivet nut to each trailer wall and secured the wheels with all-thread and wood blocks. Does it add weight to the front? Yes. Does keep the...

Just found a generic application made by Lippert. See... https://www.etrailer.com/Spare-Tire-Carrier/Lippert/LC159056.html May work just fine.

Trailer tongue is occupied with fuel cans and propane tanks. I am considering behind the axle. Easier access. Are you looking at the cradle that lifts/pivots the entire wheel or the crank type? Keep me posted.

All, My M1102 is NOT running the stock issue HMMWV wheels. I have added adapters to run the GM 8x180 (?) wheels to match my 2016 Silverado. Question: Has anyone mounted a spare under the M1102? Thanks in advance, Dennis

Sent. Dropped your name.

Thank you. Will be removing the markers and checking grounds behind assembly. If no bueno, new markers go in.

Roger that on the individual LEDs. Need to replace the entire assembly. I did a search on "Truck-lite amber lamp assembly 07407". Got these all over the place. Is there a better search term?

Photos would help...

All, I have read some associated postings but I seem to have a different type of marker light and two have failed. The failing lights are the front lower amber and they have 5 LEDs. If the power source (currently running on 12v) is common, what is the most likely issue? If the LEDs are...

I run Bearing Buddies on my smaller utility trailer and they are useful while in transit to keep the bearings packed and water displaced (cheap insurance). They come off fairly easy when it is time to inspect and repack.

You are all correct and they will inspected and repacked. Has anyone ever used Bearing Buddies on an M1101/M1102?

All, Just "re-found" this thread. Hope there are others still working M1101/M1102 builds. I am building up an M1102 and currently have completed... 1) Wheel swap to GM 8-lug 2) Fuel tray on front (Scepters and 20# propane) 3) E-track points on exterior 4) Stabilization leg relocation/mods...