Recent content by dmark4u

Hey Badrobot did you buy just the hardtop or a trailer with a hardtop on it. I've been looking for a top like this for a few years. Do you mind me asking how much you paid for it and from which base you picked it up. Thanks

Does anyone know where to start looking for a S250 shelter in Canada ? I'm in Ontario if that helps

Yes I contacted them but they do not ship into Canada or anywhere close to my location. I think I may have to get something custom fabricated.

Hello everyone I'm looking for a part number for the attached M1101 hardcover with windows and rear doors. I'm not looking for the amtech helmet as its way way too pricey for my needs I'm looking for something I can use to camp and that has some windows for lighting. i would appreciate any...

I see most are worried about removal of surge brakes I'm a structural engineer with 15 years experience in bridge designs. I assure all of you that I did every single calculation and my design is fully safe and I have a safety factor of 5 times max trailer weight. If you drive safely and don't...

I got the entire trailer coated with LINE-X not sure what the final cost is didn't get the invoice yet but it came out looking pretty good I always coat all my trailer due to the insane amount of salt the city uses here during winter.

Im running the 37s I calculated the force on the drop and it way under the capable weight. I have 2 trucks one is much higher then the other and I also lend my trailer to several of my friends So that way was perfect for me as its capable of 9 inches up or down.

M1101 tongue modification and height adjustable and LINE-X Hello everyone I ran into a problem I'm sure many of you had before. My M1101 was way too high for my truck and I didn't want one of those large plate receivers so I basically removed the entire pintle and surge break setup and welded...

Yes I agree it would be best to leave them in and tape around but it wouldn't look good at all. The line-x will be black and the trailer is sand so I want to remove them and paint them black to match. I've busted 3 sockets and tried heating the bolt to bright red and nothing. I will cut them out...

So I figured out that it's a hex size 5.5 which is very hard to find in a socket When I did finally find one it snapped right away first bolt.Any ideas I spray them with penetrating oil several times prior My next idea is to heat them up don't really like that option but I'm out of ideas

Hello everyone I'm in the middle of applying line-x to my M1101 trailer and have ran into a small issue I tried removing the tie downs and cant seem to find the proper Hex size bit . I have both metric and imperial and none fit exactly the closest I found was #5 and it spun and stripped the...

Hello everyone, new member here so don't be upset if this question has already been asked and I missed it looked and search but didn't find so here goes So I bought a M1101 trailer from NY and had it shipped to me in Ontario Canada. Now I am trying to plate it and the MTO wont let me because...