Recent content by DownRange762

I got enrolled in the other site and you were correct, he has photo documented much of what I needed to see. His example vehicle is an M38 so the source of the vacuum is different coming off the intake manifold but the overall routing is similar. Thanks again for the lead. Wade

Thanks for the lead. I'm not registered on that site but I will be in a few minutes and see what is posted.

I'm working on getting my original vac wiper motors working on my just purchased M38A1. Of course what would be helpful in making the motors move would be if there was actually a vacuum line running from the fuel pump, along the block, to the firewall and from there it is just rubber tubing...

What are you asking for the bed and do you have any photos ? Thanks, Wade

A very late response I know, but in case others with the same question search this thread, I used Haggerty Ins., with no problems to insure my FV-721 Fox. Cost is less than $275 a year and includes limited towing.

Neither. In my particular case with the insect nest obstruction to clear the vent tubes you need to blow air OUT through the vent tubes by disconnecting them further "upstream" of the obstruction. In other words disconnect the lines between the transmission and the obstruction and then direct...

Do you still have this turret?

For what it's worth, attached are some pictures of a successful non-ether re-mounting of a super single tire on the A3 rim. As others noted before, PLENTY of tire lube packed around the rim as you would if you were repacking wheel bearings, plus a couple of carge straps, plug putting the rim on...

Hmm...never noticed a panel but without three or more elbows/wrists on my arm I can't get enough grip on the spring with pliers to pull it into position. I've never noticed the panel you mentioned, but I'll be looking for it now. Thanks for the tip.

Out parking brake shoe return spring install? I've adjusted the parking brake but need to replace the outer parking brake shoe return spring as pictured in the center. It's the rusty one in the middle that had a broken end you can't see in the picture. I have the new replacement but was...

For those that were wondering and might ought to check theirs, here are the vent tubes at the back of the cab, (exterior) complete with dirt dauber nests to ensure you will blast trans fluid all over the cabin when refilling.

A look inside the wheel Some of the accumlated mud/rust/crud has been knocked out of the valve fitting but you can see the effect of water being in the wheel for an extended period. No wonder the valve was blocked.

Mystery solved If I could view the site from my home computer I'd have added photos right now but I'll do that Monday. In short, apparently during its service with the Guard, this M35A3 had the tires partially deflated enough to allow the tire to unseal from the rim while the vehicle was in...

No luck on any of the above suggestions, clearing out caches, cookies, cooties and everything else.. I agree it is something with my computer but it is odd that only the SS site won't display. Everything else from banking, Ebay, car sites, weather etc., displays as expected. I was hoping...

Doghead, I knew the base membership were free, that's why it wasn't making any sense that I can't view even the homepage from one computer. It still just displays an olive drab screen, no text, graphic or other characters. I have since become a premium member but the problem remains at my...