Recent content by EMISSARYx

IN

Alright I will give it a try. Thank you for the reply!

My rear window crank broke and the window is about 1" down from all the way closed (up). Long ago I replaced the handle/crank assembly but now I can't figure out how to get in there. I removed the panel off on the inside. I still have the key and the lock still turns. I assume the clutch broke...

Thx everyone for the help! The batteries were both new in March 2010, MAXX-65N from Chinamart. I was running my inverter at the time with a very small load of a laptop charger, I don't think it was from draining. From what I can gather the battery had a catastrophic internal failure in the...

The front battery starts at 10v and then drops down to 3v when I turn the key on, the 24v drops to 17v, it looks like the battery died?

Thx for the words of encouragement, they will help when I sit here and cry

Hi all, I need your help! I am stuck in south Dakota, here is what is happening to my m1009: 12v power was switching rapidly on certain circuits while driving, I thought it was just a bug until I stopped. When I went to start back up, the starter engaged for a second and then started clicking...

What a wonderful way to design something. Mystery punch holes. I didn't have to add any more holes thank goodness! You should take a picture next time you have to punch a hole, so you have it when someone has that situation!!!

Just finished a little while ago, it went pretty well. After I got the wheel and lock plate off I was able to pull the turn signal mechanism out a little (lazy and didn't want to disconnect the wiring), just one 5/16" bolt holding the lock cylinder in. Removed bolt, cylinder came right out...

I wish I never read that. aua

Got it, thank you! I think I have enough info now, I'll bump the topic if I get stuck. Thanks all.

Like I said I could not find any info from searching, I assume it has been covered with another topic or indirectly. Well at least there is a thread now with a specific topic on this. I'll go ahead and yank the steering wheel, and use your guidance from there!! Thanks for the reply!

Hi all, I have searched this site for a good while, and tried a basic internet search, but did not find the info I am looking for. I am surprised this has not been covered, and sadly all my experience has never led me to messing with an ignition lock. Just need to know the basic steps for...

Awesome, thank you everyone!

I found that pic while searching BTW. Judging by that setup it looks like whoever owns that truck and radio could identify that plug. Nathan Wilkens if you are reading this I hope you don't mind me borrowing your photo from this link for educational purposes.