Recent content by graham

When I bought the truck about a year ago when you go to shift into fifth gear it would jump out of gear. I put new synchronizers in it but it still jumps out of fifth gear but I noticed when I put the parts on the shaft were loose. Could the shaft be bad and causing it to jump out of gear?

The ones I got do from 12-36 volts. The one in the grill is 12500 lum on top is 30000 lum on the side is 5000 lum and the back up lights are 2000 lum

I finally got the truck running and took it for its first run down the road it ran great but the transmission was not so great. Third gear would pop out of you let off the gas and fifth gear would not work so I just replaced the Synchronizers third gear works great and fifth gear you have to...

How do I change it out?

Do I need to pull the transmission to change them?

I finally got some time to work on the truck and got it running again I had to set the pump 1 tooth before the line on the pump. The truck runs good now but I have another problem the transmission when you put it in 4th gear it pushes it back out of gear when you let off the clutch.

Do I need to turn it a tooth clockwise or counter clockwise but when you hit the start button if fires up on the first try with no problems

My brother and I finally got a chance to work on the truck tonight. We rest the trimming on the motor and lined the marks on the HH head and put everything together. We shot a little starter fluid in it and fired up on the first. But now it has white smoke coming out and hastate when you step...

Do I need to redo the timing on the motor and redo the HH head and line up the red marks?

This is the first time my brother and I have had to work on a diesel he bought a deuce and a half years ago and it ran fine with no problems. I just picked this one up from a police auction where it has been sitting for a couple of years but like is said it ran fine when I put new battery's in...

My brother pulled the HH head off and said the clip came off so he put it back on and put every thing back together. At first the truck would not run but if you put the gas pedal to the floor it start. It will run but not good he said you have to keep the RPM around 1500-2500 there white smoke...

Ok thanks I'll look at it in the morning when I get off from work.

I'll try that tomorrow if it doesn't move up and down then what else can i try?

I just pulled the out the plug and pushed the pin down I got fuel out of it so i put it back together and it still won't start. I'm getting fuel from the return lines at the top of the injectors but no fuel is coming out of the injector lines. If you let it sit with the fuel pump running for 2-3...

I removed the cover and the fuel rod moves freely.Is there anything else I can try?