Recent content by LuckyDog

No input at this time. Lots of wondering questions. Please keep me / us updated. I love the idea.

This unit is a Navy type asset, but I figured I would start here looking for information. Have the following: C-7439 Antenna Coupler C-8006 Radio Set (A unit of OA-8364) Manufactured by: R.F. Communications Mated with the RF 301 Transceiver Looking for more information. Specifically any...

Don't forget to check the lines at the injectors. It is not uncommon for the little bow tie piece in the fuel injector pump to break and cause the same symptoms. Also, holy necropost. This thread is almost six years old. You might want to start a new thread for your problem. :idea:

Surprised no mentioned this: http://www.surpluscenter.com/Electrical/Miscellaneous-Electrical/Enclosures-Panels/120-240-VAC-GENERATOR-PANEL-BOX-11-3306.axd I mounted one to my 002A and a 50 Amp welder plug. I have a second one that I may put a SOJ cord on, to plug into the panel and get away...

The pump models are outlined in the Wiki. (link in my signature)

First guess is... if the manual doesn't say to change the small wires, I wouldn't. The small wires just monitor one of the windings for voltage and adjusts the excitation voltage/current. Now, after looking at Figure 14 (pic#3), I don't know how that VR works. But if it works, I wouldn't try to...

I was thinking more along these lines: http://www.surpluscenter.com/Electrical/Switches/Toggle-Switches/SPST-35-AMP-TOGGLE-SWITCH-CHROME-HANDLE-43034-11-3452.axd http://www.surpluscenter.com/Electrical/Switches/Toggle-Switches/SPST-35-AMP-TOGGLE-SWITCH-W-BOOTS-43035-11-3451.axd I have this...

I've been contemplating a switch. Something that can do 15 Amps for a 002 or 30 amps for an 003? Then you just throw the switch to bond or un-bond the neutral. Been thinking about it.

No reply yet, because it is a bit sticky to do what you want. Maybe not sticky, but there is much to consider. WARNING what I am about to tell you may be illegal to do in you municipality. Contact a certified electrician. Caveat Emptor. In 120 Single Phase, the output is across L1 - L3. With...

Follow the link in my signature to the Wiki (MEP 002A and 003A). Second post is by Speddmon. In his signature is links to all the TM's for the MEP002A and 003A. That is the easiest. There is also forums from the main forum page that have all kinds of TM's.

I might suggest that when you get it back together with the new cam shaft, do the flow timing check in the TM. Easier and maybe more accurate than the dial indicator. TM 5-6115-585-34 Page 7-38 h. Adjust/Time on Equipment. (1) Time the injection pump to the engine by using the proper...

Go here to see what is in the parts kit. Pic of Parts

Hey Bross, I'm waiting............. :papabear::whistle:

I am subscribing to see how he hooks the surge brake to the M101 axle. :burn:

The on-board outlets only take the 120 from 1 winding. Do not overload that outlet. Make up a box with outlets and wire it to the output lugs. This is the panel I started with then modified to take advantage of the full power of my 002A. Generator Panel ETA: (Of course, I don't know the model...