Recent content by M1009

Hankooks rock!!!!

10-4 I'll check it with a friend turning the steering wheel

Ever hear a weird knocking noise when you turn the steering wheel? it sounds as though its close to the drivers floorboard, and only seems to happen at slow speeds. i have checked everything that could be loose and it all looks fine., torsion bar?

I added a brown gas, hydrogen generator to my m1009, getting the leaks fixed on the differentials will put it to the test next week.

Added my hot water shower system, works great!

I had video surveillance installed onto my house after a couple of *******s tried to steal my F-250 twice in two weeks, then they tried to take it even after the video was installed - one night I just happened to park my CUCV next to it in the driveway then like clockwork at 0300 they walked up...

JustAdded a roof rack to carry extra cans, get the big tire out of the cabin, and holds the pioneer rack that i picked up over the weekend perfectly, also made a shelf to hold the solar panel and i have room for what ever else i can think up. i used flat bar to keep it looking like the front...

Payson Arizona 7,000 ft

i found a CDR valve at Courtesy Chevrolet it was $25.00 i bought a new one to put on the truck and now i have used cleaned one as a back up, and yes it does run a whole lot better. The Mlitary show was a lot of fun this year - I was kinda shocked as to how much attention my rig was getting -...

I have 35's on mine and they work great! with a six inch lift... does not bind or rub, they are on 15 inch rims. I have chewed thru these tires over the years so i have some TOYO open country Muds on order I ordered them 6 months ago still not in! - very hard to find tire, I know this because...

As far as the scalding water you had mentioned - I am using a mixing valve, that should solve the problem and I haven't seen one any other system.

Yes its made by Alfa Laval and the numbers on it are TK 2c25411g01 - CB14-10HS R16 ? not sure what the numbers mean but it has 10 plates an the dimensions are 8"L x 3"W x 1.5" thick and it uses 3/4" fittings. search on Ebay - the thicker the unit the more heat retention.

Hey guys, I am putting this project together - have done a TON of research on this - and i think i can do it better than anything i can buy. I am going to be able to take a HOT shower by using the coolant of the radiator and some military style engineering. Not only should it look cool, but...

Since i have it on my side i might as well take a few pictures. should be easy.

No holes in the transfer case, the leak has been there... just not as noticeable before the fluid 's were topped off, I am guessing your right, I will check the seals and replace them. Thank's for advice, I will post the results.