Recent content by M35A2 KAISER

If you are asking about the single axle dump. It started out as a m101a2, but we like to refer to it as a m101 highboy nowadays.

Here are a few more pics. M101a2 removed fenders, welded in new sides, stake pocket, and side rail. Built a sub frame that pivots off of the rear lifting points with some length ways supports to keep the rear frame from twisting. I used a littlegiant geated dump hoist my grandfather bought at a...

I will get some pictures off of my old phone to show some details give me a couple days.

The LED tailights are mounted in premade boxes made by Buyers Products, the boxes were made to be mounted horz. But they fit well vert. The little side marker LED clearence lights are neat little lights you drill a 3/4 hole for the gromet. I just cut the rear support for the bed side and the...

Here are a couple of pictures of a dumping m101a2 done a little differnt.

Updated I did this temp fix almost 2 years ago and it is still holding strong and does not leak.

I removed the radiator due to a leak where the tubes meet the tank at the bottom. Radiator shop said it was unreasonable to try and fix. So i started with new belts and a couple now howes then cleaned the top of the lower radiator tank with muradic acid till i had clean metal no paint. Next i...

I have never used a ready welder, but i do have an old discontinued solar cordless 24volt wire feed welder that has 2 hatteries inclosed in the moble unit. This is handy to just grab and go weld something up to 1/4" thick and hp to 60" long on one charge. If you need more i added a set of jumper...

The top 1" of threads have been turned down and crossed drilled for a padlock, for a failsafe and a way to keep the adapter from being removed.

Made myself an adapter to pull with a ball. Adjustable coupler height so it works with polaris ranger, stock height 4x4 truck, and lifted Blazer.

As people in the military truck hobby we are just lucky glen is also, if he wasn't we may not be buing parts for the reasonable prices he charges for parts. We are lucky to have him here in the heartland.

2 new batteries and new o-ring in the shutterstat of our 936. It starts right up now and builds air much faster now.

Today I worked on one of the 923 we picked up from fort riley this week. This truck required either to start and was not very responsive to the accelerator pedal, looking in the tank could not tell condition of fuel but the strainer was a mess with rust, so the assumption was there was water in...

Today I worked on one of the 923 we picked up from fort riley this week. This truck required either to start and was not very responsive to the accelerator pedal, looking in the tank could not tell condition of fuel but the strainer was a mess with rust, so the assumption was there was water in...

My new to me 2006 Raytheon m1101. After reading some info tm says the short bow goes in the front. All 4 of mine are the same height, so the front of the cover looks to short. Can any tell me the height differnce or where to find the measurments?