Recent content by NuclearPuppy238

I had the same thing happen when I bought mine, some were bright, and some were dim. The issue was the LED module that developed fatigue cracks inside on the solder joints. I replaced mine and all was back up and bright. Ryder fleet products used to have a 2 LED module that fit the trailer (my...

That whole amber light module will need to be replaced. It removes with a quarter turn counter clockwise and there is a connector on the back. All of the spare parts are found in the link below. You can buy the amber modules by themselves, but I only found the 2 LED versions. The link below has...

Thanks, Now I am wondering what the tongue weight is without anything on the back, just genset and the AC unit. I will take a guess it will be close to 300lbs or more.

Does anyone have a pic of the shipping plate for this trailer that has the dimensions on it? Width is standard, but not sure how long these are. Thanks in advance,

I just replaced all the markers on my M1102 except the three reds in the rear with all new parts because I made a big mistake. Do not use blue thread locker on the light housing screws as it eats the plastic and causes it to crack. Yellow 12-24V LED assembly. PN: 7407...

Opps

Sorry to hear about the bear, and good luck with the repair. Here we have tons of rats, so it is always a battle to keep them from building nests in the engine area of the cars.

Finally stopped raining. Images taken when the top is dry and in the sun...mostly.

Yes, I have the vinyl top. I used spray paint from the Rapco Parts website using the C.A.R.C. substitute colors. I chose them, because I can order any mix of colors per case. I did test the paint on a test area to see if it will "eat" the vinyl. No issues were seen, and the paint sticks just...

After looking at the price of a new "canvas" top, I decided to refurbish the one I already have. It took about 3 coats of paint on the outside, but care was taken to not make the paint too thick or it would start to look glossy. I had a few holes along the corner area along the sides that...

They are 37 x 12.50" x R17LT.

Perfect for getting a spare tire in and out!

I had similar on my M1102 trailer, all of my amber LED marker lights were flickering randomly, or going dim. It turned out to be a fault internal to the sealed units and nothing to do with the wiring. Replacing the LED modules fixed the issue I had.

I didn’t want to drill any holes to mount the license plate, so I wanted figured out an alternative method. Instead of finding a welder, metal stock to fabricate something, I cut up the top half of a scrapped rear leg support, and mounted an inexpensive license plate holder to it with...

I also tried to search the dimensions of the trailer pintle ring before picking mine up. Here are a few pics with dimensions of the pintle ring on my M1102 for reference. Hope the measurements are legible. I used a 10-ton hitch that worked pretty well, even when backing the trailer into the...