Recent content by rebel5909

On flat ground if you back up and try to jack knife it the trailer toung hits the rear bumper beside the pintle hitch and the two beds are about a half in apart so its close but doesn't hit. If you wanted more room you could slide the trailer bed back a lil farther before you bolted it down but...

Ok good that's what ill do thanks

Do you think cutting them on the outside of the ten lug pattern will work good? That way you leave as much wheel as you can but the old pattern is gone

I have a guy building me some bolt on plates. Have any of you guys installed these before? I need to know where to cut the hemtt wheels

I have had 4 or 5 hundred pounds in it and I couldn't even tell it moved so I would think it would take quite a bit for it to hit but just in case you could allways build you some bump stops

usafss-coldwarrior here are the pics you asked for. i welded 3 supports (4"x6" angle) across the frame under the original brakets that held the bed to the truck and then bolted thru those bed brackets into the angle. the reason i did this is because the trailer frame is wider then the bed frame...

I allways stick mine between the seats. It doesn't work good for thin cups or on bumpy roads but i catch myself sticking my bottle of water there alot

I can get more pics and have them on here in the next couple of days I would say it has about 200 pounds toung weigh. I know I wont try to lift it by myself but three of us did the other day. I centered the bed right over the axel

This is my latest trailer m200 with a Deuce bed in this pic the bed is just sittin loose on the trailer with a 4x4 block holding it up. I don't have a more recent pic but now the bed is sitting down lower in the rear I had to weld supports under the trailer and then I bolted the bed down to the...

i have 6 hemmt wheels with the 5 ton bolt pattern i need someone to weld me in plates to convert them to 2.5 ton pattern i dont have the plates just the wheels i have some stuff to trade (rear truck axle, 105a2 axle, rear truck walking beam suspension and some other things if you can help me...

I flushed my system with denatured alcohol then bleed with brake fluid all the componets checked out ok! the truck is back up and running great and im back to making money with her! Thanks for all the help!!!

ok i got the denatured alchol yesterday i plan to flush it after this rain is over then i plan to bleed it with dot 5 thanks for all the information guys i will let you know how it works out im hopeing my componets are fine but i will check them over and dont worrie its parked til fixed i wont...

:driver:this truck is my every day driver i need it back on the road so any information will help me out!!!

for the past few months my breaks on the deuce have felt funny but it still stoped well yesterday i had to slam on them and it went stait to the floor but finely stop. after that i had none i can pump them three time with ease and it goes strait to the floor but on the forth time the pedal is...

does anyone want to do some tradeing? i have a m200 genny trailer with the generator removed im lookin for a shelter or box to put inside my m105 trailer to use as a camper