Recent content by recon

weight of 9x20 tire and wheel

how toreplace brake and clutch bumper pads

In manual 9-2320-209-10 the cooling capacity for the LDT 465 is listed at 28-32 qts. Why the range? Recon Dutchess county, NY

what is the correct length wiper blades for the m35a2? I have looked through the forum and couldn't find a consensus. I tried finding the length in the tms but length was not mentioned. Recon Dutchess county, ny

I need to replace the temp sending unit on my m35. I've been putting PB buster on the fitting. Anything else I can do to ease getting the old unit out? I've found a lot on testing temp sending units and temp gauges but nothing on torque for installing sending unit. Should a sealent be used...

Just went through this problem. Put new oil gauge in last May and it worked fine until 2 weeks ago. Gauge became erratic and would pin at high end. Checked ground but it became erratic again. Put in new sending unit. No change. Problem was wire connecting gauge and sending unit. Replaced wire...

Replaced oil pressure gauge and checked sending unit. Found sending unit was 120psi and pressure gauge was 60psi. Now they match. Washed truck for parades. Recon Dutchess County, NY

Thank you Mangus for all your efforts. recon

B3.3T, you are correct.

Here are more pictures from the Ropkey MV show. I hope!

I'm still trying to get the pictures in the post.

A few more vehicle pictures from the Ropkey MV show.

Saw this and other vehicles at the Ropkey Armor museum outside Kokomo, Ind. recon

I've been to Ropkey's a few times. It is a great place. There is a really big Viet Nam veterans' reunion the same weekend just outside of Kokomo.

I have a '71 kaiser m35. About a year ago or so I put an AVM lockout hub on the front rear axle. Just recently I took the Deuce out for a drive after sitting for a month. The axle was in 2x mode. After 30 miles I was putting it away but I could not get the hub to move into 4x4 or 2 x. The...