Search results

Need to pull my dash apart and clean the light sockets so that my lights all will work all at the same time. Wile I am doing this I am thinking about installing red leds. In place of the stock bulbs. What are your thoughts on this?

Any one have any pictures of a M1009 with a artic kit installed? If so please share. Thanks

Installed a new radiator in my m1009 about almost two weeks ago. Topped it off and filed up the over flow tank to the line. Checked it Saturday and the over flow tank was empty, radiator was full. So I fill the over flow tank to the line again just figured it had a bubble sense I charged both...

I know this has been asked before on here but can't find it with my phone. How do you fix the volt gauge on a m1009. Mine has not worked for a long time. I replaced the gauge way back but it still did not work.

Looking to install a temp gauge in my stock m1009. What have you guys used that have done this. Don't like the idiot light. Never had a problem with her over heating, just want to block of the radiator in the winter to get more heat in the cab and would like to be able to keep a eye on the temp...

Anyone have a good part number for the rubber oil coolant lines that go from the engine to the hard lines at the radiator? One of mine is starting to weep oil.

Here lately been having problems with longer than normal start times. Replaced all the glow plugs and ends because they where bad. Now it takes longer crank time than it did before or starts. Yesterday drove 20 minutes home shut it off went in the house for about half hour or so went back out to...

Any one now the part number and where I could get a new oil fill / vent cap for my 86 M1009 6.2 lit diesel? Thanks.

Any one bringing some new style tarp bows for the m101 a2 trailer?

Volt gauge not working. Replaced gauge and still not working. Help please.

I know this has been discussed before but could not Find it. Looking to replace the front and rear springs on my m1009 but can not remember the length of them. If anyone could tell me thanks.

Started my truck this morning, and after it started I pulled the light switch to turn on my running lights while I when back inside to let the truck warm up. But I pulled it out to far abd turns the headlights on so I quickly pushed it back in not to shine my head lights thru the neighbor's...

I am looking for 6 or so of the screws that hold the fiberglass side boards on the metal side post.

Is there any other electrical problem, other than a bad starter solenoid that would cause the starter to just spine and not engage. It does this intermittently, it will go for weeks and not do it and then it will do it every other time and then back. My M1009 is all stock. Thanks.

I am sure this has been asked before, but I am going to ask again. Sorry. How much of each color does it take to paint a M1009?

Any one know where I can get some nutzerts and screws that hold the fiberglass side boards and bow pockets on. I need 6. Not sure what they are called. But I know them as nutzerts

For anyone how has installed a 6" lift on there M1009, did you have to do any drive shaft work.

I am getting white smoke from both tail pipes, when I start my truck and it is cold out. Any thoughts? Normal? It did not do this until my glow plugs started going bad and even now that I changed to all new ones.

Trying to figure out what is going on with my M1009. It whants to pull to the right when going down the road, it does it more when the tempertures out side are realy cold than when it is warmer. I do not think it is a break caliper sticking because it will do it way down the road after breaking...

Any one ever installed a duramax and alison in a M1009. Is there enough room to fit this set up in the wheel base of a M1009?