Search results

Many places that sell alternators will bench test your unit for you, usually at no cost.

On the m1028 - hid headlights and a am/fm radio

The dog did not look too concerned, so - but after you check the other items and you still can't find the problem- it might be a good idea to get your oil analyised. It is a cheap check on your engine internals and usually is the first indicator massive problems that if you act quick they can...

how do you feel about working on a M1028a1?? inspiring!!!! you are to b commended on a job well done!!

A properly serviced air dryer should protect the air system, i agree with doghead, keep it simple!!!

great news!! These vehicles are very easy to work on just take one step at a time and you will get there

take a look at the wiki - it gives you a look at the m1008 - thru m1030

Correct methods make for sucessful results, diagnos the problem, repair the defects - life goes on!! As they say- anyone can change parts/ not everyone can fix the problem. Bottom line if you can't figure out the problem- find someone who can - it will be cheaper in the long run!!! Proven time...

one other thought - if this unit has a mechanical fuel pump- check for oil for presence of fuel. Oil contaminated with fuel will result in loss of oil pressure

Can you re-purpose the existing one? you will not need it for anything else - right?

welcome to the best forum on the WWW. best of luck! Pete

doghead - you da man!!!! Right on diagnosis!

got any more??

very nicely done and at a resonable cost!!

last friday was faced with no start condition, was sitting in 6 in of standing water so i waded in ,hooked the chain and drug it inside. slightly puzzling - had 2 fully charged 12 volt batteries but no start. could not confirm the presence of 24 volts - found junper cable loose on one of the...

The weakest link, be it chain,truck,u-joint,driveshaft or stump!!!

Nicely done, may we ask how many $$ it cost + it looks like there was a little welding as well? Who/where is tsm? Couple hours of work?

i wish you would bring back your old avatar, for the life of me after seeing it i must ask what are we talking about? Oh to be one of santa's helpers! The wild and crazy headlight nuts usually bake the headlights 10 minutes @ 270 degrees f to separate lenses from the housings. Don't forget to...

according to the page linked above it only covers the original purchaser

put on a new set of tires installed new G/P card replaced defective G/P relay replaced all Glow Plugs PERRRRRRRRRRRRRRRRRRRRRRRRRR!!!!!!!