Search results

Welcome neighbor.

Yes, i have an ad in the classifieds. $120.00 a plate plus shipping. HEMTT wheel adaptor plates for Deuce and a half - Steel Soldiers::Military Vehicles Supersite

I finally got time to make some plates. Some guys were asking about how they bolt up differently. You can remove the outer studs, and press them into the new plate. Assemble the wheel with the plate underneath, and bolt together as normal. This allows you to mount the wheel on the truck, and...

I believe it was Jesusgatos, and he had made some.

Welcome fellow Michiganders. Be careful, these trucks multiply.

I'm looking for tires too. 14-20's for my big truck, and some 395's for 2 trucks.

Sounds like i need to come visit you, and drive around town.

Man i feel sorry for you HOA guys. I have room, but it's a bitch of a commute.

Yes, don't be scared of ether, just spray for a second. I ethered my 813 today, and have every time i've started it under 40 degrees. Batteries were a little low, but she fired up fine. There is a reason why it's called "starting fluid".

I have 36 wheels to pick up in Columbus, Ohio. Going to Pontiac, MI 48340. I can unload with a hi-lo. Mike

I just did this a couple days ago. The glass does not have to come out. To install, put the striker assembly up in the door, close to final position. Then pivot the the other end up in position, jam your arms up in there, and you can feel how to get past the regulator arms. Don't be...

I pulled my 2 out of there yesterday. One didn't need anything, the other needed brakes bled, and a jump. Drive home went smooth.

Sorry i didn't have any advice. I've never had the trans apart...........yet.

I have some trades set up now. So unless something falls through, i'm all set.

Looks like quality work to me. Nice job.

Thanks for the clear up Dudley. Nobody should be bashing anybody over some hunks of metal. If you need to pick my brain you know where to find me.

You seem to be using "manufacturing experts" in a negative connotation. We spoke privately a month and a half ago. I told you i was interested, and told you stamping was cheaper. Last we spoke you offered to send me a rim, i showed interest and asked you for the rough sizes so i could quote...

I spoke to Dudley a month or so ago that i could make them. I just needed a wheel or a print. Fortunately for me, unfortunate for you guys, i got a bunch of work from GM. That takes priority. If you guys can have some more patience, i see no reason i can't sell these for $100.00 dollars...

Every Hemmt wheel out there, plus 99% of every production steel wheel has been stamped, and pierced in a die. The cost outlay is the tooling, but i do it for a living, i own the machines to build the dies, and i own to presses to stamp them in. Material cost is the unknown right now. But i...

Never say never.:wink: