Search results

There's no way to check the fuse is there in the link?

Yes it's coming out of that one , I'm about to ask two stupid questions how do you use the volt meter and how do you replace the fusible link the directions w the volt meter suck

It's conected the corecct resistor not sure of the volts

The screws that were mounting it were to long I was putting new ones on that would keep it tight the screw driver contacted the top red wire and there's a burn mark on the relay I will test the top wire was hoping it didn't find its way to the card to was thinking I shorted the relay out ?

I was mounting the relay to the wall and sparkles went flying the screw driver contacted the relay grrr, glow plug system isn't working now is it possible I fried just the relay and not the card too??!!

Also I had a buddy put a new steering wheel on and he lost all the horn parts that wouldn't be a culprit either would it ? He put the screw back in the lost the contact rings

Every thing looks good except where someone cut the military trailer harness and out a civi one on

I would probably have a better chance winning the lotto than finding what's draining it haha

I keep leaving the dash light power switch on and keep having to charge the battery it seems to only drain the front one. I know the best solution is to remember to turn the toggle back off , but what is the best way to jump the m1009 off , and is it possible to do w out cables and what is the...

I replaced the relay with a factory one. I charged the batteries replaced the relay card, replaced the relay and wired per schematic, replaced all the fuses and she fired up! I also printed a 1000 pages of TMs and put them in a binder! THANKS GUYS!!!!

Yes this is going to be painful, i replaced and rewired the relay per the schematic removed the wires for switch. The picture with the light blue has a plug on the end of it and goes no were and cant find it on schematic, it comes out of the same bundle that comes out of glow plug module, I also...

ii

Thank you! You wouldn't care to suggest a few page numbers? I found one schematic in 34 Tm but no detail on wich wires are wich

yes i do have those downloaded i have a awful time with them though

I have a multi meter never used it yet

I would like to reconfigure it correctly , I would not like to have it down for a while , how do I test and make sure it's grounded correctly I guess where do I begin ?

How do I do that? Any picture that would help for me to take for you to look at?

I was hoping you would see the post! Which blue wire? One from in engine compartment? What do i need to do with the to wire going to the push button glow plug switch? Thanks for your help as always doghead!!

I know its not factory , i didn't put it on. The switch worked good for a month then started burning up, its wired with two 10 gauge red wires one looks to be coming off the coil pack and the other the power bar. Any ideas? i replaced the switch with a 20 amp switch and with in a few minutes it...

Had alternator put on saw this anyone know where it goes I'm assuming somewhere on alternator since that what it has enough length for ?