Search results

How big of a problem is the water pumping in a different direction ?

They don't use the same injector pump ? So find one with a timing chain?

Very very true all I can do now is move forward , I believe a engine swap may be the cheapest solution? Any idea where to find a good one ? Do the hummer take outs drop right in?

Like before I bought the truck

I contacted them too and sent pictures but got no reply , haha , I discovered the other hole is elongated and the flywheel is worn bad from grinding , I'm wondering if it would b more cost effective just to find a good engine , I'm not sure the problem wouldnt resurface again if by some miricale...

GL motor I believe

I need a motor I've got a bad block not sure if I should rebuild one or get one of those hummer motors, not sure if the hummer motor will drop right in??

Your not sure what your getting then also though right? Found a hummer motor for 1100 that's running , I've been looking at the classifieds on here. Not sure if it would b cheaper to rebuild or find a running engine , a good running engine .

I found a old m1009 engine that the owner says was pulled due to low compression would this be a good candidate ?

anyone know the name of the salvage yard in Tullahoma that has cucvs?

To add to the level of difficulty they also threaded out the whole bigger on the block and starter, I got a gear reduction starter, could i make the hole bigger, or could I tap the hole deeper and put a longer bolt in there, how deep can i go w the right handed hole?

OH how funny doghead , yes I did that made me laugh. It was painful but I looked at -20

Very true, sorry hopefully a mod can move it, and thank you

The only response I got back was no knowledge of it

Anyone have any pictures of new style starter bracket installed on truck Anyone have any pictures of the new style starter bracket installed on truck where does it mount?

Cucv parts , doesn't sound good for a close salvage yard.

Do you happen to remember his name?

Very good point I don't have the missing part of metal either I'm defiantly gonna call them I've got nothing to loose thanks ducer!

Any salvage yards in south east T.N. ?

I'm gonna call them in the morning not sure if it can cover that large of a area I checked out the web site and read a bit about it, there is a 2 inch long and probably 2 inch deep section missing