Search results

Right, that what I was thinking of doing, but the GP Controller card looks fine, the GP look fine (tested them all have .08-.09ohms)... I'm going to look at the resistor bank in the back of the engine now and i'll take a photo of that. If everything looks good, and working properly, then I wont...

I added photos. But anyhow, dug into the truck today, removed the GP card, cleaned it up, and removed the GP themselves. The card looks fine with now burnt spots on it, and the glow plugs look ok.. The connectors to the GP were a little loose and i will replace them (what color connect would be...

I've searched "new glow plug controller" at the parts stores, and i've seen what it looks like, but I can't find where it is located under the hood. I searched for the 86 k30 6.2 glow plug controller. Is this correct?

i hear ya, The glow plugs relatively new, but the connectors look at little iffy. Where can i get new connectors? and is there a way to test the individual plugs? Remove them and check resistance?

Well, I bought this 86 CUCV M1008. it is having a terrible time starting. I've just replaced the fuel and air filter. I can't start it with out removing the air cleaner housing and spraying some number 5 silicon in the intake manifold. until today. I've tried to start it, turned the key to...

sounds good, should I try to override the relay by sending power to it directly? (using jumpers).

Thank you all for the great input. I've purchased a new air filter and fuel filter. Now with the glow plugs, they look relatively new, still have the nice shine on them. But for the glow plug controller, how would you know if it went bad? Any way to test? Resistance Test? Thank you! I will keep...

When cold won't start w/o spray...even then Just bought a 86 6.2L m1008 cucv military truck. The seller told me that it does have a little bit of a hard time starting in the morning. What he says he does is press the accelerator half way down and turn the truck on (glow plugs). Then use...