Search results

Items have been arrived well. Both have same outer diameter 2.01 and fit very well. Installed the pa cargo item, because it was machined better, than the ac delco, no sharp edges etc. Seal taken from the Timken 5208 box. Thank you all for your help.

Hey guys, Contacted John from the Hill Billy Wizard. He has sended a card to me. Maybe it will be there in one week. Many thanks to Karl (antennaclimber).

Thank you folks [thumbzup]

I'm thinking about just using the contact on the glow card for the WAIT lamp (as it is functioning at the moment). I mean, its providing ground during WAIT lamp is on. I could use it, to energize an additional relay, which would provide ground to the glow plug relay. OK, i would not have the...

Got the response today. They have checked the card. All components are ok except the IC. They have said, that this IC has been created only for this special purpose and its not buyable here in Germany. So, had someone such an 'IC' failure in the past and was able to repair it? @319cssb, I...

Still waiting for the electronic shop response. Checked the Hill Billy Wizard shop in the meanwhile. It seems, that they dont offer this cards anymore. Know someone this guys? Is there also an other source for this cards? Thank you.

Hey guys, thank you for the information. Doesnt found the part number in the 20P manual, but in the 34P (3978765). Also found here some information: https://www.pirate4x4.com/forum/chevy/1214290-np241c-tailshaft-bushing.html It looks like NP 208 and NP241c use the same bushing. Contacted...

Is it position nr. 3? Unfortunately cant find a part number for this position.

Hi folks, I have removed this days the tailhousing from my NP208 to change the rear output shaft seal and bushing. I have ordered TIMKEN 5208 from rock*uto, but it is so, that the bushing is just too smal, it falls thru the hole :-( Bushing, what I got has 48mm inner diameter and 50,75mm...

Ahahahaa

A bit of heat from the 2000W heat gun (approx 80 degree celsius) a knife and a hammer done the trick :) Thank yuo for the great support friends :)

Thank you for the tip. Checked the 'gap' and actually, there is not really a gap :cry: Maybe i should do it like this guys? https://www.youtube.com/watch?v=uZ5yXRM24wQ

Hey guys, my NP208 is here on my table and I would like to change the rear output seal and bushing ( TIMKEN 5208 ). Seal was leaking and the bushing seems to have wear marks. Outputshaft has no radial or axial play. Anyway, removed the 4 bolts, which hold the tail housing, but can't get it...

Sended the card to an electronic repair shop today. Lets see :-? Will keep you up to date.

Had today a closer look to the card. Nothing strange, black or brocken pins. Asked here a local electronic shop via email, if they can check the card. Let's see. If i understood it right, a transistor has always 3 pins, collector (C), basis (B) and emitter (E). But this one 4, I mean it has 3...

Will check that today later. But in general, transistors are these 3 guys in the red rectangles, correct? Oh, or is it the flat one, with 3 pins?

Thank you thank you guys :-D Have bought it here in germany from a belgian guy and driven the truck just maybe 400 meters, not more. It has 4" lift with blocks in the read, original axles and 37's. It was rusty, durty, loud and from everywhere came oil out, means engine oil pan, tranny and the...

Thank you for the information Sir.

Do you mean this 3 guys here? Karl, dou you still develop this glow cards? If yes, how much do you call for them?

Thank you all for a 'warm' welcome :-D