Search results

I finally got to installing the hemtt rims and 1600 xzl . Pulling the thimble caps was a bit of a pain some snapped the ends off so welded the nuts to the ones that did to get them off . Very happy with the ride pulls hard still a bit more down shifting . I used Alcoa 5995 recessed nuts .. so no...

I've been researching the mechanical N14 it's essentialy a 855 a bolt in I would probably run a 15 speed behind it and the T138 case. I am no expert. With your own research you can find the right info .

What about a mechanical Cummins N14

Yay tires arrived today

Check your electronic control box I had a very similar event happen with my 813. Changed the control box everything worked.

Here is my own nomination. My 813 cheers ,

Hi guys I've tried the search and no luck tried oil change , oil etc etc no find .. What are you guys using for oil I have the Rockwell service manual here and it clearly states to only use GL 1 90 weight oil which is a mineral base and to not use higher gl rated oils as they are not mineral...

And this is the truck finished using the same gun and settings

This is the gun I used it cost me $120.cdn , as for settings I did not cut the paint I turned the air up I ran 100psi and a inline water separator .[ATTACH]519509[/ATTAC

I connected mine to the spare dash light wire. The unit comes As a plug and play order what ever length you want I got mine on eBay . The info below was translated from a German site sorry 24V BATterie connect. - Lifetime up * to * 50,000 hours - Mit self-adhesive tape on the back (3M tape)...

Installed 24v red led cockpit lights with dimmer

.

Took mine to the trucks expo today and saw this guy there to

There is a open valve you can tap into under the dash on your 813,has a shut valve on it already drivers side .

Just back from dinner and a drive

Have a look here may help http://www.seatbeltextenderpros.com

Working on the hardtop I've fixed the squishy bowing roof with 1/4 flat bar

Not a,mv but I just painted my buds FJ fde. Behr marquee exterior .

These are couple of pics I found of a bridge truck.

The M123 runs duals but there 1400 24R . would likely be to wide for legal road use.