Search results

bet you got some fuel gelling going on let us know what you find!

doing the doghead swap will not change the starter output or make it spin any faster just a switch to activate the starter! is all it is.

:ditto:fuel will not gell at 20 deg. not overnight so that is not going to be the problem been in the teens here and below no problems. would check above first. have you checked and drained water off filter base that will freeze at 20 deg.

Will have to say looks alot better then what I had pictured in my head when you said 14'' body lift! [thumbzup]

If you look at the old one the big part there is a number on it also to tell you size

The tranfer also uses trans fluid so will not be dif. in color. As for idea I would guess you have a output shaft leak look at the rear output rear drive shaft were it comes out of the transfer case is it all wet if so seal is leaking also the front drive shaft at transfer there is a seal that...

Welcome to the site!

Welcome to the site! good luck with the new ride. when you get that far you can check and if the plate is not used by anybody you can get it back the dmv can check if its used in about 3 seconds !

The trailer light plug should work. the plug will be on the under side driver side rear corner you can look at plug before you buy. they are standard. I just remove the military plug and wire in a 7 prong trailer plug keeps everything neet and clean with no wires hanging to catch on anything and...

Be careful with body lifts most states here in the us have laws agains useing the body lift. I would not recomend over a 2'' body lift with grade 8 bolts for safty reasons just my two cents seen alot of bad things over the years with body lifts going bad being in the 4x4 buisness. terryh not...

Oh bye the way I told you that the gov was behind a cover with a spring clip that is on the turbo 350 sorry for that the turbo 400 is behind the cover with four bolts holding it MY BAD!!!

If you cant find a gov at your local parts outlet you can get a used one from a salvage yard or order a new one online one place would be TSR-Racing Products at tsr-racing.com or 800-349-5889 a new gov assembly part number #400-34410 fits 1964 and up turbo 400 and calibraded for gas is 29.95 +...

Looks good! Nice job![thumbzup]

:ditto: I would agree going to be a ground problem !

If your truck is still set up with the 24 volt starter then the jumper socket will be 24 volts you can change the leads that supply the jumper socket and put on the front battery and then use it !

Keep in mind the hollander is a bolt on book if you have to change anything on a part to make it fit like a temp sender it will say its dif. so a good start but not really set in stone may have a heat sheild on the van manifold. just info! and yes I know there are no temp senders on a exhaust...

Yes you will need to change the flywheel! And as stated you should change the converter and gov springs but as stated will not burn the trany up unless trany is bad to start with My brother has one with a deisel trany and as stated the shift points are way off but has run for about 2 years now...

Also a little note . Most of the newer stuff uses neg switched lites and the older stuff like the cucv uses pos switched lites just keep in mind so you check what the system you get was made for rather it will work on what you want to put it on as far as the lites anyways! just not plug and play...

the front plow mount off of the 1500 will only fit if the truck had a live axle under it back about 1988 they went to the idependant front suspention and the frame was also wider so it will not just bolt on Before that 1/2 ton ,3/4 ton and 1 ton chevy , gmc trucks the mounts were the same as the...

Gods speed krall ! Be safe!