Search results

Gravity feed the fuel pump to see if it is working properly. If it is, you should be able to bleed the air at the fuel filter and the truck should run. This means you have no fuel getting to the lift pump. If you can not get fuel out of the filter, your lift pump is bad. You may have more...

Thanks for the kind words. Unfortunately all of the GP cards with the additional heat option have been sold. It was a limited production run and most likely will not be offered again. Karl

Fantastic job!!

Sounds like you have a battery failing under load. Load test both batteries.

I had a M1009 that had a similar issue. I finally found the drain plug on the bottom of the fuel filter base was not completely tight. After tightening it the stalling issue never happened again.

Here is the resistance chart for the glow plug sensor. Measure it without the wires connected. The high idle sensor is a switch, it is either open or closed. Karl

I found the fast idle switch and the solenoid on Amazon. Search for ACDelco 10154649 ACDelco 14066255

The resistor is located behind the air cleaner on the fire wall. This thread will help you locate it and do the bypass. http://www.steelsoldiers.com/showthread.php?121398-GP-Resistor-Bank-Bypass This thread will help you understand the GP system and how it works...

You may want to consider this modification to the firewall mounted 24 volt bus bar to get a good 12 volt connection point. It's not hard to do and is reversible. http://www.steelsoldiers.com/showthread.php?95803-M1009-Rear-power-24v-to-12v-modification&highlight=radio If properly done, this...

The wait light should always have +12 volts on it from the fuse box, the ground for the light comes from the GP controller to turn the light on and off. Check the dark Blue wire that comes out of the GP card connector to see if it has rubbed thru anywhere and is now connecting to ground. If...

My M1010 does the same thing. The M1008 and M1009 do not

Thanks for the nice comments. And Thank You to all that have purchased cards. The cards are made by a USN Viet Nam veteran and myself. I served in the USAF, NY and PA Air National Guard way back in the 80's. I also employ a prior service Marine and an Army Iraq Combat Vet. Recently the Army...

Minor correction, it is 100 amps that 8 AC60's draw at 11.3 VDC. We use these 100 and 150 amp breakers in vehicle radio installations. http://www.delcity.net/store/Hi!Amp-Surface-Mount-!-%3Cbr%3EManual-Reset-(Switchable)/p_193073

From what I have found, Carmine is a bright red. I have painted all of the interior burgundy parts in three CUCV's with this color and it works very well. This is very close to the OEM color. http://www.eastwood.com/burgundy-interior-paint-aerosol-12-oz-net.html One of the dash pads was...

A good set of tire chains is hard to beat. There are all different types for various conditions. Mud, Ice Snow etc. Driving skill and knowing your limitations are critical in conditions like this. I think you made a wise choice and turning around when you did. Karl

I use these relays for our projects at work. They work well as a GP relay and snow plow relay. http://www.murcal.com/Catalog/Metal-DC-Contactor-Family/974-1215-011-09

TriFlow is fantastic. We buy it by the case. It works very well on keeping things well lubricated.

The holes are for the antenna mounting bracket. The trucks looks great.

Additional pictures without the extra wires.

Take your pick. This is from a M1009. The white and red wires are not stock.