Search results

The truck has a Tractor protection valve on the frame. Try to test the valve, leave the red hose stored on your truck and then push in the dash valve. The dash valve should say in, if not the valve maybe bad. Or the TPV maybe bad or the air supply to the valves.

I remove the plugs then just pump the grease in then replace the plugs. Or you can install a zerk and then when your done replace the zerk with the plug. You need to remove the two plugs not just one due to letting the air out when you pump the grease in.

I would take a air hose. Yes, I would change the front tire for sure. The Truck has air brake. no master cylinder.

Well that S**&. I would just try back later. Also I have started using AW68 here is AZ for my Hyd things.

There is a place off of 43 ave. South of I10 that sells 10w oil, that is were I get my oil's. Arizona Petroleum 602-252-0922 ask for James. 4247 W Adams, PHX

I think they will go to the range to be shot at or the shredder.

:ditto:

I think the TM says to push the throttle the way down and then turn it over, it may take a little before it starts.

Looks like a nice ride. Glad you had a safe trip.

You will need to take the wheel apart and clean it up (painting will be needed) and replace the o-ring. When you take one of these wheels apart they are always rusty. Also always replace the o-ring when you take the wheel apart.

Nice job!!!!

I put a NOS cab on a Deuce and I think it was for a A3. The only thing I had to do was punch out the holes for the clutch and brake pedal and use them to fill the holes from the pallet mount bolt holes. The mounting holes for the bright light switch were 90 degrees off from a A2 cab, I just...

I still have not done my m923A1 but I looked at it and it looks looks it will not be to bad. Need to add the Trailer Air supply valve and a Tractor protection valve. Then tee in to the wet tank and the brake supply line. Let us know how it goes and what you did, take some pics!! I think the...

Here in AZ in the summer time they do get hot. They will not all be the same, but should be close. I have seen 135-145 in the summer time. In the winter time when I hit the car wash before a show or display you can have steam come off the hubs. The first time I saw that I went oh s&#$%^. I...

:ditto:

Hope you have a safe trip and enjoy the truck!! Just do your checks on the truck before you head out fro home. Fluids all around, tires, brakes, lights, etc.

Way to go, nice!!

The one hole in the bell housing should be open, the other one with the plug is just a holder hole for the drain plug. You move it over to the open hole when you have to go into water.

Wrap it with some tape then cut it off with a little cut off wheel, like a 4.5' grinder.

The little FYI that I have ran into with the wreckers is fill the tires to 90psi, drives a lot safer and nicer. I was driving my wrecker with only 70psi in the tire (11.00x20's)and I hit a bad spot in the road from trucks making groves. There was some puckering go on then!!!!