Search results

OK, I have a head scratcher. This was the screen I got after replacing the screen, I had swapped CIM's with another 'B' that I have, and it worked just fine, so I stick the original back in, still no go, soooo it sits on the broke line waiting its turn to get back in the shop. I go out today...

The T from the 5th wheel to the pintle appears to be at the tractor protection valve which is located on the frame just to the front of the air dryer directly below the pogo stick. That would be another place to check. https://www.youtube.com/watch?v=-1vA1EnNJZ4

I will look at mine tomorrow to see. I will bet there is just a T under the 5th wheel air hoses that directs air to the rear.

Mine has a red valve and blue valve that shut of the air at the bottom of the pogo stick right on top of the deck, so that when you pull a pintle trailer all your air doesnt leak from your 5th wheel trailer hose. Photo to come in the light tomorrow.

What was under the plywood flooring under the tile? Is that what the 4x4 beams on 12" centers and spray foam is?

Went to give you a thanks on your post, and its not there...... Thanks for everything patracy

The head may be a bit pricey, it has a built in primer pump. Mine isnt available at this time or I would get you some better photos. It is being used to heat a gym so if it warms up here, I will go take the top off to get some photos of the head for you.

Here is a pic of the fuel filter and number if that helps. Wherever you get the filter, just ask if they have the number for the head.

I have air filters that are the same length exactly, diameter in 1" smaller for better air flow. Photo comparison to original in my photos, in parts file

I cant give you an exact height, when the tap measure got to 14' I stopped measuring. Since this photo has been taken, I have removed the 14.00/20's and put on 11R24.5's, I lost about 1" overall height. I need to move a box trailer around this weekend, I will use 'Rock Chucker' and try to...

When you get your new screen you will have to replace the metal back from the old screen to the new screen. Reason... there is a heater on the back of the old screen that was glued on and I couldnt get off. It was simple, six itty bitty skrews and 4 bend tabs. Also including a photo of the pn of...

Luckily, I do have another 805B with a very good screen, looked new to me, so now to just find a computer nut to pull the fill out of 1 and put it in the other.

I had no clue where New Boston, TX was..... to my surprise.... its Hooks.

I wondered if there was a different driver for the different screens, only reason I got an exact pn replacement, see if that helps things, if not.... well i have a spare screen.

I placed mine control panel to the rear, thats why there is a platform there so why not use it. With the trailer not hooked up to the truck, do you have to have the rear legs down with this setup to keep the balance correct with you standing on the platform?

I dont know why either, take 2 bolts out, roll the shaft, take 2 bolt out, roll the shaft, take 2 bolts out then roll the half shaft off the rotor. But his initial question was about getting the brake cable off. I know I get side tracked while doing a project then end up forgetting what I...

there is a C clip that holds the brake cable in the bracket.... item 7

delete please, double post

I did replace the screen with a China version but now I get this screen if you cant read it.... it says 'Unbootable device available r- reboot s- setup esc- bios debugger' I did not use an exact part number replacement, the one I used was a direct replacement. So I ordered an exact part to...

I have not had a response or had time to play with green iron. If you don't mind taking a measurement for me. I either have money and no time or time with no money