Search results

Austin (beltfed34) is absolutely terrific.

I can make the plug with 1/8 inch steel and my plasma cutter or maybe I should just go sloppy with a square 4’x4’ steel panel of cold roll, like I did on my M1165. I have square 1/8 Aluminum sheet for several of my flying nun roof M1151 slantbacks.

Tie rod or driveshaft bent? Can’t argue with everything else. I figure at least 6 months of tinkering to get her almost reasonable to drive.

I can’t seem to find the link to Mikes Eco Hubs. Search disallows three letter words.

And thank you too sir.

Thank you sir!

Then I gotta start asking about those hub things (???) you all are using to increase top speed and comfort. Will also fit a water tank and sprayer for those pesky Cali wildfires. Figure it should be able to hold a few hundred gallons of Adam’s Ale, for purposes of firefighting. And thank you...

Well, I need a bigger vehicle for some work pulling larger trailers AND camping and probably doing some emergency type volunteer work. Purchased a 13,000 mile Cali FMTV. Not running. Bent driveshaft. Time to cry. Then read TM’s and post here. I own several HMMWV and an H1. I guess I’m...

RWH is the king. My comments are general and not specific to HMMWV. If superficial, use a short Dremmel to rip a slot across the top and a stubby flathead screwdriver to remove. If deep, use an aluminum or copper pipe to protect threads and flux core wire to build up a neck and then weld that...

Helps if you tell us year and model HMMWV. ie: 1987 M998 three speed 2007 M1151 four speed or the first theee digits of your VIN

Credit card chargeback

Rear steer is not that difficult, and now that it is appearing in GM vehicles there’s a good chance that you will be able to obtain those parts in several months as they begin to show up in junkyards. You can also review rear steer from other vehicles listed on the Internet with instructions on...

Radio killing batteries because PO wired into batteries rather than harness, meaning when the key is out the radio is still on. 🙄🙄😣😣 FFS. Now I need to pull the doghouse cover in 30 degree temps. (For you citizens of the Great White North, I don’t mean that ridiculous French Revolution...

Check the link in my signature line. That integrated circuit causes more trouble than it is worth.

IIRC, might have been Springer 1991 on the main HMMWV thread. Haven’t seen him in a while (BUT maybe because I have him blocked).

YouTube has several decent videos on how to source parts and rebuild rear and front calipers.

Remember that if too much oil begins to leak, the engine will use that oil as fuel and you can get a runaway engine. Fixing the problem by replacing the cartridge is prudent.

Spinning and digging can snap your half shafts when they finally engage the ground. I’m not saying it doesn’t work and I am not passing judgment. Also, never go from reverse to drive to reverse to drive without letting all the wheels completely stop. You will crack your half shafts otherwise...

Rebuild your box. My signature line contains the instructions. It will be much more robust afterwards.