Search results

I have a 1971 M35a2 with an engine rebuild date of 1989--The mains are .010 over--37000 miles--It has a c- turbo and runs fine--There is blow by coming out of the hose hanging down the passengers side of the engine and out of the oil fill hole when the cap is removed--How much blow by is...

Can anyone help me on this--I may purchase a HMMWV in Mexico--I would have to import it through customs--Customs says any vehical coming back into the US must meet DOT and EPA standards--Are there any stickers anywhere stating anything about emissions or dot--Thanks George

Purchased an M818 from GL--No year was given for the truck--Made by Kaiser--How can you determine the year----What is the grease tube located on the drivers side next to the clutch housing lubricating and how are you to load the tube since it has no fittings--Thanks

On my m35a2 the turn signals do not flash--when i turn on the signal the bulbs outside light but no flash--the light on the turn signal does not glow--when i disconnect the wiring to the fender mounted flasher the turn signal light does light--i have tried running ground wires from the battery...

Hi--does anyone know who sells Aervoe paint in NJ--I remember some guy out by Cherryhill --Has anyone used Aervoe and how well did it cover--Thanks George

just tried to pick up an 818 at lakehurst--started up fast after i put in new batteries--coolant tank was empty so i put in 1/4 gallon of antifreeze before it came right out the right bottom of the radiator--there is a large metal support under the radiator so i cannot see where its coming...

have to tow an m35a2 with a built up front bumper with no place to hook up a tow bar--i purchased the axel chains and towed an m35 last week but noticed the chain assembles slide back and forth about 3 inches--is this common and what is the proper hook up for the chains--thanks george

will wheels off an m35a2 fit on the m211--thanks george

when i start my m818s in cold weather and use the cold start system the light above the switch does not come on in one truck but comes on in the others-- is there a circutr to check out--what are the correct cold start steps--thanks

Hi--My name is George and I just joined--I would like to say hello to everyone--This week I purchased an 818 out of Lakehurst NJ--The truck sat there for 1.5 years--It started with a jump but has a binding accelerator pedal in the wide open throttel position--I tracked the bind down to the...