Search results

If you want a potential switch fire....and possibly burnt wires......then take a chance. I just shipped some donor wires and switch connectors to a shop in Az. because of the neat Elect. light switch. The good'ol lever switch is the way to go.

That master cylinder only came on A1's and up.

There S/B plates on inside bed on fender walls, and tailgate also.

24 v compressor with proper wide surp belt pully are available [ redot or factory ], and can have a 12v relay with 24v pass thru when activated to operate compressor. Same thing with relay can be done with the R/H fender unit which is readily available cheap.

One or the other.

The M102xx series trucks get the thin stuff....M104xx series get the thick stuff.

It ain't no 2004....its a late 80's truck

I guaranty its cut. They don't have the time to do the extra work to remove body properly which needs to be done. you'll need trans X member, rear and mid drive shafts, maybe rear diff. yoke, dual brake light switch, shifter .

Oh...I forgot....Send that front bumper this way...youuuuuu donnntttt neeeed iiiittt.

Looks good...hey,...looks like if you put the swiss cheese mount up on top...you won't be able to get the truck out of the garage . Also...get rid of those fender soft top brackets.

M9988-nut is libbster29

In a 94 hummer manual [ civi ]...6003599 is 1994, and 5938794 is earlier.

I have good columns available with or without a wheel. i made my own puller....auto store units are to wide.

Its not bright, but it worked for the test,,,12360890-3. Type base is bayonet, Ba9s [ 9mm ], 28vdc. Standard bulb is a 1819

Check them with an Ohm meter....if nothing....there bad....if 000, there bad If around 1.3 or above ohms....good, but most in your pic look bad. I have new ones if needed.

I tested 25 Nartron units...they all did not work until I changed the bulb in the switch to an LED.

LED light test : Tested the directional lights and found : With all four Grote led's , and a incandescent light bulb in blinker switch : thermal switch made by Swiss controls [ 12418344 ], Aurora Cord [ 11613631 ], and Riverside Mfg. [ 11613631 ] lights work as they should. The Nartron 11613631...

This from an earlier post: I put 16" trailer rims and trailer tires for pulling behind a 3500 Ram. Leveled out fine, and tires are available anywhere., If using it with the Hmmwv, then swap out the tire/wheels. Trailer rims have a big center hole to fit the trailer hub. Cucv wheels dont fit due...

96 and below had a different 4l80e....cooling system upgrade on 97 and above. 96 and below had both cooling tube connections side by side, same as 3l80 [ 400turbo ]. 97 + cooling tubes are seperated, and pans are different.

Only the Hmmwv 400 [ 3L80 ] trans had no park, but could be added.