Search results

I'm in Gloucester County

Nice, I got my deuce from George. Where are you located in NJ?

This sounds like a lot of fun if I could get off work. I'm very close to the Paulsboro stop on the Red Serial route.

I got one of the frost plug style heaters a few weeks ago, but have yet to install it, so thank you for the install info! I wish it would stop snowing so I could get it put in!

Yeah I 100% agree that this would probably cause more problems then it's worth, but it's an intriguing idea. I wish I had a beater truck to fool around with it on. I think it would be pretty neat to start and warm your truck up from inside the house. It would be mighty impressive haha.

Has anyone thought about installing a remote starter in a 900 series truck? I was thinking it would be possible. I'm not sure if there is 24v remote starters, but I have a 12v circuit that I could use to power the unit...and then maybe use a relay that trips with 12v and outputs the 24v. Not...

This is the lower kit. http://www.amazon.com/Haldex-Midland-DQ6020-Housing-Repair/dp/B0046PEL2I/ref=pd_sim_sbs_auto_1/190-9182226-5112661

Yep, I did the upper and lower. I just didn't get as many pictures as I should have, I get too into the projects to stop and take them. After the rebuild, the dryer works great. I would always rebuild the whole thing, it's definitely worth it.

Sweet!

Sorry about the delay guys. I didn't get as many pictures as I should have, but hopefully these will give you an idea of the process.

I had the exact same problem with my truck. You need to reset your fuel shutoff linkage. Your emergency cutoff switch was most likely pulled. It's a simple fix.

I actually need a gear for one of my lights as well. It must be a common problem with this model. Mine were brand new and only lasted a few months before one stripped out on me. If anyone has them I would be interested in purchasing a couple as well.

Great advice. I just did one a couple weeks ago by myself and I neglected to buy a new clamp. Big mistake! What a PITA to reuse the old one, especially with the buggered up thread!

I had the same problem, it turned out that I just had to reset the fuel shutoff linkage.

I have a M923A2, and I don't have a CDL and Im not going to. I use it for fun and have it registered Historically, and everyone I have talked to said I do not need one. Plausible deniability.

Thanks I did read through that last night, and I will go through it, was just hoping someone had this specific problem before and could help.

It is cranking but not firing. It cranks fine. If it isn't really hot, like after a short drive, I can get it to fire after three or four long cranks. If its after a long drive and the engine is really warmed up, it will crank and crank and then it will fire and die. It sounds like a fuel issue...

Hi, I need to bounce a problem I am having off of everyone. When my M923a2 is cold, it starts right up like a top. After I drive it and warm it up, then shut it off, it gives me a really hard time starting...sometimes so hard I can't get it to. I'm not sure where this problem lies. Could it be a...

Thanks for the replies. I did order both of the kits from Ryder. I removed my air dryer after work today, and started taking it apart in my shop. Man that thing was nasty inside, I'm really glad I decided to dismount the entire unit and clean it up. There are a bunch of tubercles and other junk...

Thanks, I did notice there was an upper and lower kit after I posted. The filter shown on the kit I linked and the one Ryder carries is the same one I have on my truck. I guess I'll just order it and give it a shot, seeing as I don't see any other rebuild kits.